Results 51 to 60 of about 719,745 (217)
Analysis of systems for cooling liquid injection in turbine engine gas flow duct
Авіаційно-космічна техніка та технологіяThe subject of this article is a system for cooling liquid injection in gas flow duct of aviation gas-turbine engine (GTE). The goal is to soften the acuteness of contradictions between economic and ecological requirements; ecological requirements and ...
Ruslan Tsukanov, Sergii Yepifanov
doaj +1 more source
Improved performance of a hybrid radio/fiber system using a directly modulated laser transmitter with external injection [PDF]
, 2002 A directly modulated laser diode with external light injection is used to generate microwave optical signals for a hybrid radio/fiber system. The external light injection greatly enhances the frequency response of the laser, and thus, significantly ...
Anandarajah, Prince M. +2 more
core +1 more source
Design and Verification of Electron Injection Unit for Small-Size Betatron
Applied SciencesBetatrons offer advantages such as a compact structure and the absence of complex radio-frequency systems which make them well suited for industrial non-destructive testing and high-energy X-ray imaging.
Qi Liu +5 more
doaj +1 more source
Diesel engine fuel injection monitoring using acoustic measurements and independent component analysis [PDF]
, 2010 Air-borne acoustic based condition monitoring is a promising technique because of its intrusive nature and the rich information contained within the acoustic signals including all sources.
Gu, Fengshou +7 more
core +1 more source
DA-FIS: A high-speed dynamic adaptive fault injection server framework for reliable FPGA-based embedded systems [PDF]
PeerJ Computer ScienceFault injection is a critical technique for assessing the reliability of field programmable gate array (FPGA)-based embedded systems, particularly in radiation-prone and safety-critical applications.
Fatimah Alhayan +7 more
doaj +2 more sources
Development and design of binder systems for titanium metal injection molding: An overview
, 2013 Titanium metal injection molding (Ti-MIM) has been practiced since the late 1980s. Logically, the Ti-MIM practice follows the similar processes developed for the antecedent materials such as stainless steel and ceramics.
Neil Edmonds +9 more
core +1 more source
Geofluids, 2021 In this work, a triple-porosity, two-phase flow model was established to fill the knowledge gap of previous models focusing on gas production characteristics while ignoring the impacts of water injection.
Ershe Xu +6 more
doaj +1 more source
Evidence and information for national injection safety policies [PDF]
, 2003 The adverse consequences of poor injection practices have been reported for a few decades. However, key elements of evidence and information were lacking to allow decision-makers to formulate policies for the safe and appropriate use of injections.
Hutin, Yvan
core +1 more source
International Journal of Hepatology, 2012 Flow injection/sequential injection analysis (FIA/SIA) systems are suitable for carrying out automatic wet chemical/biochemical reactions with reduced volume and time consumption.
Supaporn Kradtap Hartwell
doaj +1 more source
Injective Envelopes of Operator Systems
Publications of the Research Institute for Mathematical Sciences, 1979 We show the existence and uniqueness of a minimal injective operator system (resp. minimal unital C *-algebra) "containing" a given operator system. V , which will be called the injective (resp. C *-) envelope of
openaire +3 more sources