Results 21 to 30 of about 1,143,025 (97)
ABSTRACT Aqueous zinc‐ion batteries (AZIBs) hold great promise for safe and sustainable energy storage, but their commercialization is impeded by severe Zn dendrite growth and interfacial instability. To address these challenges, we propose a defect engineering strategy employing ultrafine ZnAl2O4 (ZAO) nanoparticles (∼5 nm) with oxygen vacancy defects
Yilun Ren +9 more
wiley +1 more source
The Microstructure Evolution and Mechanical Properties of (FeCoCrNi)100‐x(AlCu)x High‐Entropy Alloys
ABSTRACT This study systematically investigates the effects of AlCu addition on the microstructural evolution and mechanical properties of (FeCoCrNi)100‐x(AlCu)x (x = 0, 5, 10, 15, 20; at%) high‐entropy alloys (HEAs). The results reveal that the microstructure evolves from coarse equiaxed to refined equiaxed, dendritic, and ultimately dual‐phase ...
Shunfu Xie +7 more
wiley +1 more source
ABSTRACT The polyanionic compound Na3V2(PO4)3 (NVP) has emerged as a competitive cathode material for sodium‐ion batteries (SIBs), owing to its high‐voltage redox activity (3.4 V vs. the Na+/Na reference couple) and NASICON‐type framework that enables superior ionic conductivity.
Xiaolei Wu +5 more
wiley +1 more source
ABSTRACT The similar physicochemical properties of alkali metal elements make the co‐enrichment and precise separation of Cs+ and Rb+ in complex brine systems highly challenging. Here, an all‐inorganic strategy is proposed, which achieves efficient enrichment and precise separation of Cs+ and Rb+ in high‐salt systems by constructing Sr2+/Ba2+‐based ...
Kang Li, Ruixin Ma, Shina Li
wiley +1 more source
ABSTRACT This study introduces novel nonequiatomic TiZrCoCrMoCux (x = 0, 5, 10; at%) medium‐entropy alloys (MEAx) tailored for orthopedic implants, synergistically combining the biocompatibility of Ti‐based alloys, the wear resistance of CoCrMo alloys, and the antibacterial/osteogenic attributes of Cu. The alloy's microstructure, mechanical properties,
Hang Yu +9 more
wiley +1 more source
ABSTRACT Enhancing the strength of 7000 series high‐strength Al alloys remains a critical challenge to meet the demands of increasingly demanding service environments. In this study, a novel approach is proposed for developing high‐performance Al alloys through a combination of powder mechanical alloying, powder press‐forming, rolling deformation, and ...
Peng‐Fei Ji +4 more
wiley +1 more source
非均相沉淀法制备Ba_3MgSi_2O_8:Eu~(2+),Mn~(2+)荧光粉 [PDF]
用非均相沉淀法首次合成了名义化学式为Ba2.88MgSi2O8:0.02Eu2+,0.1Mn2+的Eu2+、Mn2+共掺杂Ba3MgSi2O8荧光粉。用XRD、SEM和荧光光谱进行表征,并与相同条件下用高温固相法合成的荧光粉作对比。研究沉淀反应温度、金属离子浓度对非均相沉淀法制备荧光粉相纯度和发光性能的影响。结果表明:相对于高温固相法,非均相沉淀法可在更低的温度下合成相纯度高的荧光粉,且粉末颗粒呈近球状,粒径均匀,粉末基本无团聚;沉淀反应温度为40℃,在此温度下,金属离子溶液滴加完毕后,继续搅拌2h ...
刘晓兰, 曾人杰, 陈毅彬
core
该文报道了一种改进本征吸杂技术--低温短时热退火工艺,以增强本征吸杂效果,在本征吸杂工艺的低温热退火中,用连续的线性缓慢升温(Ramping)退火替代常规的长时间低温恒温退火,应用于直拉(CZ)重掺N型硅衬底片,明显增加了氧沉淀等体微缺陷密度,这些高密度氧沉淀物在随后IC器件工艺中继续长大,成为稳定的高效本征吸杂中心。从经典的成核沉淀理论 ...
韩秀峰 +8 more
core
为考察含砷硫酸烧渣中酸浸脱砷效果和铁盐沉淀固砷行为,采用常温常压酸浸法脱除硫酸烧渣中的砷,并对进入浸出液中的砷以铁盐沉淀的形式脱除,进而对沉淀渣的浸出毒性进行研究。同时,研究了磨矿细度、酸浓度、固液比、浸出时间对硫酸烧渣中砷脱除效率的影响。结果表明,通过控制浸出参数可以将硫酸烧渣中砷的质量分数降低到0.2%以下,通过调节浸出液的pH和Fe/As摩尔比将其中的砷以沉淀的形式脱除。当Fe/As> 2、pH=4~6时,溶液中砷浓度降到了0.5 mg·L-1以下。沉淀砷渣主要是以非晶态的形式存在 ...
肖力 +5 more
core

