Results 271 to 280 of about 3,259,652 (338)

Geometry‐Based Scan Curve Analysis: Rapid Method for the Evaluation of Scan Strategies in Powder Bed Fusion

open access: yesAdvanced Engineering Materials, EarlyView.
This study presents rapid evaluation methods for scan strategies in powder bed fusion (PBF) of polymers with a NIR laser as an example for its application. It uses line buffer‐based calculations and point density fields to predict the performance of four different scan strategies. The methods show promising results in laser‐based PBF of polymer samples,
Simon Leupold   +9 more
wiley   +1 more source

Effect of Water Aging on the Mechanical Properties of Hybrid Carbon/Aramid Reinforced Thermoplastic Composites

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the mechanical properties of Carbon/Aramid intraply hybrid fiber‐reinforced Elium composites under 6 months of water aging. After aging, flexural strength decreases by 25.89%, tensile strength by 4.40%, and fracture toughness by 21.56%.
Muhammed Huseyin Guzel, Gurol Onal
wiley   +1 more source

Overview of Torsion Tests on Fiber-Reinforced Concrete Beams. [PDF]

open access: yesMaterials (Basel)
Domski J, Lehmann M, Sanok A, Tvrda K.
europepmc   +1 more source

Femtosecond Single‐ and Double‐Pulse Fabrication of Periodic Nanostructures on Stainless Steel for Surface‐Enhanced Raman Spectroscopy

open access: yesAdvanced Engineering Materials, EarlyView.
Periodic submicron features are fabricated on 304 stainless steel using single and double femtosecond laser pulses. By adjusting polarization, fluence, and inter‐pulse delay, 1D and 2D nanostructures are formed. Enhanced hydrophobicity and dense surface‐enhanced Raman spectroscopy hotspots enable analyte detection down to 10−10 M with good ...
Balaji Baskar   +3 more
wiley   +1 more source

X‐Ray Computed Tomography Quantifies Primary Phases and Reveals Crack Morphology in High‐Cycle Fatigue of Aluminum Alloy EN AW‐2618A

open access: yesAdvanced Engineering Materials, EarlyView.
Primary phases and a fatigue crack are studied in a forged blank of an aluminum alloy using synchrotron and laboratory X‐ray computed tomography. To image the crack, the fatigue test is interrupted, and a static tensile load is applied to open the crack.
Jakob Schröder   +6 more
wiley   +1 more source

150 лет коффердаму

open access: yesЭндодонтия Today, 2020

doaj  

Tribology of ZrC Coatings and Spherical Tips Acquired with Extraordinarily Stiff, Metal Atomic Force Microscopy Probes

open access: yesAdvanced Engineering Materials, EarlyView.
In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk   +4 more
wiley   +1 more source

Molecular analysis of the emergence of Allium cepa L. Seeds response to saline stress and treatment with essential oil of Cordia verbenacea. [PDF]

open access: yesSci Rep
Dos Santos CAL   +9 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy