Results 161 to 170 of about 3,775,945 (197)
Surface and Coatings Technology, 2008 Systematic microstructure characterisation of plasma nitrided (350-500 degrees C for 10 to 30 h) 17-4PH alloy was carried out using SEM, XRD and TEM. Experimental results have shown that the microstructure and phase constituents of the plasma surface ...
Li, Xiao-Ying; id_orcid +2 more
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Failure Analysis of a 17-4PH Stainless Steel Part in an Exhaust Fastener
Journal of Failure Analysis and Prevention, 2021Despite high level of attention in the process of making metallic fasteners, failure of the fasteners happens in various industries. Sometimes, failures are recognized during the quality control checks in the companies. During a batch of production and during assembly test, failure of a 17-4PH stainless steel part in an exhaust fastener was seen.
Masoud Yousefi +3 more
openaire +1 more source
Sintering of 17-4PH stainless steel feedstock for metal injection molding
Materials Letters, 2008 Abstract The sintering behavior of 17-4PH stainless steel feedstock for metal injection molding was investigated in the temperature range of 650–1050 °C. Effects of sintering conditions, such as sintering temperature and sintering atmosphere, were examined.
Xing Yang Liu
exaly +4 more sources
Effect of shot peening on the microstructure of laser hardened 17-4PH
Applied Surface Science, 2010Abstract In order to investigate the influence of shot peening on microstructure of laser hardened steel and clarify how much influence of initial microstructure induced by laser hardening treatment on final microstructure of laser hardened steel after shot peening treatment, measurements of retained austenite, measurements of microhardness and ...
Zhou Wang +3 more
openaire +1 more source
Characterization of 17-4PH alloy processed by selective laser melting
Materials Today: Proceedings, 2017Abstract Additive manufacturing (AM) has revolutionized the way that engineering products are created through a simple concept of layer by layer addition of a part. Metallic components and its alloys have attracted worldwide attention due to the near net shape output and for the challenges posed in arriving at a high quality component.
P. Ponnusamy +4 more
openaire +1 more source
Additive manufacturing of 17-4PH stainless steel
2nd International PhD Student’s Conference at the University of Life Sciences in Lublin, Poland: ENVIRONMENT – PLANT – ANIMAL – PRODUCT, 2023Aleksander Świetlicki +2 more
openaire +1 more source
The modification of corrosion resistance of 17-4PH stainless steel by cutting process
Journal of Manufacturing Processes, 2020Abstract It is well-known that taking high-speed dry cutting as the final process of manufacture is a new kind of green manufacturing technology. However, the service performance of the machined components must be evaluated before applying this new technique to industry widely.
Guoliang Liu +6 more
openaire +1 more source
Sintering of 17-4PH injection molding feedstock
2015Sixth International Conference on Advanced Manufacturing Technologies, June 19-21 2006, London ...
Ye, Hezhou +2 more
openaire +1 more source
Effect of scanning speed on laser deposited 17-4PH stainless steel
2017 8th International Conference on Mechanical and Intelligent Manufacturing Technologies (ICMIMT), 2017Laser metal deposition (LMD) is one of the additive manufacturing technologies that is used in the production of fully dense parts layer by layer. This innovative manufacturing process has the potential to reduce the weight, time and cost of manufacturing components.
Abiodun Bayode +3 more
openaire +1 more source