Results 171 to 180 of about 2,702,368 (200)

Additive manufacturing of 17-4PH stainless steel

2nd International PhD Student’s Conference at the University of Life Sciences in Lublin, Poland: ENVIRONMENT – PLANT – ANIMAL – PRODUCT, 2023
Aleksander Świetlicki, Mariusz Walczak, Mirosław Szala   +2 more
openaire   +1 more source

Effect of scanning speed on laser deposited 17-4PH stainless steel

2017 8th International Conference on Mechanical and Intelligent Manufacturing Technologies (ICMIMT), 2017
Laser metal deposition (LMD) is one of the additive manufacturing technologies that is used in the production of fully dense parts layer by layer. This innovative manufacturing process has the potential to reduce the weight, time and cost of manufacturing components.
Abiodun Bayode, Sisa Pityana, Esther Titilayo Akinlabi, Mxolisi Brendon Shongwe   +3 more
openaire   +1 more source

Microstructure and hardness investigation of 17-4PH stainless steel by laser quenching

Materials Science and Engineering: A, 2012
Abstract Surface hardening of 17-4PH was achieved by laser transformation hardening using 5 kW continuous wave CO 2 laser system. The microstructure of the laser-quenched sample was investigated by optical microscopy, transmission electron microscope and 57 Fe Mossbauer spectrometer. The hardness profile was determined by a Vickers hardness tester.
Zhaoyun Chen, Guijuan Zhou, Zhonghua Chen   +2 more
openaire   +1 more source

Analysis of Additively Manufactured 17-4PH Stainless Steel

2019
Master of Applied Science (MASc)
openaire   +1 more source

Hydrogen-Assisted Fracture of a 17-4PH Airplane Wing Component

1992
Abstract Cracks were discovered in the cast 17-4 PH stainless steel outboard leading edge flap support of an aircraft wing during overhaul inspection. Failure analysis focused on an apparently intergranular area of fracture surface. It was determined that the original mode of crack growth was cleavage, probably caused by cast-in hydrogen.
openaire   +1 more source

Fused filament fabrication and sintering of 17-4PH stainless steel

Manufacturing Letters, 2022
Yaozhong Zhang, Aljoscha Roch
openaire   +1 more source

Vibration characteristics of 17-4PH metal material extrusion thin plates

Rapid Prototyping Journal
Purpose The purpose of this study is to set up the theoretical model for predicting the vibration characteristics of 17-4PH metal material extrusion (MME) green and sintered parts, as well as carry out the experimental validation and sensitivity analysis.
Shijie Jiang, Yuntao Zhang, Shuo Liu, Shanggang Cai, Hongwei Ying, Jiaqi Chen   +5 more
openaire   +1 more source

Pitting corrosion behavior of friction-surfaced 17-4PH stainless steel coatings with and without subsequent heat treatment

Corrosion Science, 2021
Dawei Guo, Chi Tat Kwok, L M Tam
exaly  

Heat treatment response of additively manufactured 17-4PH stainless steel

Materials Characterization, 2023
H R Lashgari, Leopoldo Molina-Luna
exaly  

MECHANICAL PROPERTIES OF 17-4PH STEEL, HOMOGENIZED VERSUS AS RECEIVED CONDITION

1964
Abstract : For the particular heat of 17-4PH steel plate involved, homogenizing treatment improved the ductility as measured by the reduction of area and reduced the spread in ductility data ,or each aged condition. (Author)
openaire   +1 more source