Results 111 to 120 of about 4,567,195 (228)
Modelling of dynamic recrystallisation of 316L stainless steel using a systems approach [PDF]
, 2007 This is the post print version of the article. The official published version can be obtained from the link below.Dynamic recrystallisation (DRX) is an important aspect for industrial applications in hot metal working.
D.A. Linkens +7 more
core +1 more source
Virtual and Physical PrototypingMaterial extrusion (ME) based additive manufacturing has gained much attention as a cost-effective method for the fabrication of complex metal components, particularly using 17-4PH stainless steel.
Yulin Liu, Audai Al-Akailah, Fuda Ning
doaj +1 more source
CoatingsThe surface of 17-4PH martensitic stainless steel was laser-cladded with Ni60 and Ni60+nano-WC composites and a comprehensive investigation was conducted of the microstructure and wear mechanism.
Jie Wang +6 more
semanticscholar +1 more source
Effect of TiC Content on Microstructure and Wear Performance of 17-4PH Stainless Steel Composites Manufactured by Indirect Metal 3D Printing. [PDF]
Materials (Basel), 2023 Huang X +5 more
europepmc +1 more source
Influence of intrinsic and artificial defects on the VHCF properties of 17-4PH stainless steel
Procedia Structural Integrity, 2016 AbstractIn the present work, fatigue test results in the very high cycle fatigue (VHCF) regime are discussed. Experiments were performed with smooth specimens in which crack initiation mostly originated at non-metallic inclusions. Additionally, the influence of small artificial defect, i.e. circumferential notches, drilled holes and corrosion pits, was
Schönbauer, B.M., Yanase, K., Endo, M.
openaire +1 more source
The International Journal of Advanced Manufacturing TechnologyAdditive manufacturing offers significant advantages over conventional technologies and continues to expand in the industrial sector through the incorporation of metallic materials.
Elena Monzón +4 more
semanticscholar +1 more source
Metalurgija, 2018 Fused filament fabrication combined with debinding and sintering could be an economical process for 3D printing of metal parts. In this study, compounding, filament making and FFF processing of a feedstock material containing 55 vol.
J. Gonzalez-Gutierez +5 more
doaj
Sintering Behavior of Bi-Material Micro-Component of 17-4PH Stainless Steel and Yttria-Stabilized Zirconia Produced by Two-Component Micro-Powder Injection Molding Process. [PDF]
Materials (Basel), 2022 Basir A +3 more
europepmc +1 more source
工程科学与技术, 2013 :Liquid nitriding of 17-4 PH martensitic precipitation hardening stainless steels was conducted at 430 °C for different time using a complex chemical heat-treatment, and the erosion corrosion resistance of the nitrided samples was evaluated. Experimental
wang jun
doaj
Journal of Advanced Joining ProcessesDue to its high strength, corrosion resistance, and toughness, 17-4 Precipitation Hardening (PH) stainless steel is widely used in aerospace, petrochemical, and marine industries. Additive manufacturing (AM) technologies enable the fabrication of complex
Muhammad Irfan +6 more
doaj +1 more source