Results 161 to 170 of about 3,639,238 (295)

A geometrical-based approach to recognise structure of complex interiors [PDF]

open access: yes
3D modelling of building interiors has gained a lot of interest recently, specifically since the rise of Building Information Modeling (BIM). A number of methods have been developed in the past, however most of them are limited to modelling non-complex
Abdul Shukor, Shazmin
core  

Self‐Powered, Ultra‐Sensitive InGaAs/ITO Nanowire Radial Junction Infrared Photodiode for Low Flux Imaging at Room Temperature

open access: yesAdvanced Functional Materials, EarlyView.
This study reports a self‐powered InGaAs nanowire photodetector achieving single‐photon‐level sensitivity in the shortwave infrared at non‐cryogenic temperatures. The device demonstrates high‐speed imaging capabilities even under extremely low‐flux conditions.
Kosala Dhanawansha   +10 more
wiley   +1 more source

GeS as an Emerging OTS Material: Atomic Structure and Modeling of ON/OFF Switching

open access: yesAdvanced Functional Materials, EarlyView.
The structural puzzle of glassy GeS, an advanced memory‐selector material, has finally been disentangled, revealing a patchwork of mixed tetrahedral and trigonal species. Under a high electric field, over‐ and under‐coordinated Ge and S defects, together with three‐membered rings, form an interconnected network associated with localized and extended ...
Andrey Tverjanovich   +13 more
wiley   +1 more source

Custom made rover based 3D laser scanning and mapping system.

open access: yes
Custom made rover based 3D laser scanning and mapping system.
Jamshed Iqbal (82302)   +5 more
core   +1 more source

In Situ Interfacial Assembly of Dynamic Semi‐Interpenetrating Biopolymer Networks for Robust and Mechanically Adaptive Droplet Interfaces

open access: yesAdvanced Functional Materials, EarlyView.
A dynamic interfacial semi‐interpenetrating polymer network is constructed by sequential assembly of β‐sheet‐rich SF and CS‐RL. The SF framework provides mechanical strength, while dynamically associated CS‐RL enables local rearrangement, allowing droplets to rapidly reconfigure without loss of interfacial integrity.
Yaping Zhang   +7 more
wiley   +1 more source

Low‐Flicker‐Noise MoS2 Transistors Enabled by High‐κ Rare‐Earth Oxychlorides for Mixed‐Signal Electronics

open access: yesAdvanced Functional Materials, EarlyView.
Single‐crystalline LaOCl and GdOCl form atomically abrupt, Cl‐terminated interfaces with MoS2, enabling near‐ideal switching and suppressed flicker noise. Carrier‐number‐fluctuation analysis yields effective noise‐derived interface trap densities of 1.15–1.94 × 1010 cm−2 eV−1, approaching hexagonal boron nitride levels with high‐κ coupling.
Chanho Lee   +10 more
wiley   +1 more source

Home - About - Disclaimer - Privacy