Results 91 to 100 of about 1,708,417 (385)
Effect of geometry on the mechanical response of additively manufactured polymer
Polymer Testing, 2021 In recent years, there is an rise in adoption of additive manufactured parts as end use parts. The increase is especially apparent in an aviation industry, where benefits such as shortened supply chain and parts on demand enabled significant cost savings.
Yongjie Zhang +2 more
doaj
Analysis of 3D-printed metal for rapid-prototyped reflective terahertz optics [PDF]
, 2016 We explore the potential of 3D metal printing to realize complex conductive terahertz devices. Factors impacting performance such as printing resolution, surface roughness, oxidation, and material loss are investigated via analytical, numerical, and experimental approaches.
arxiv +1 more source
3D Printing in Medicine, 2022 3D printing is revolutionizing the medical device landscape through its ability to rapidly create patient-specific anatomic models, surgical instruments, and implants.
Brian G. Beitler +6 more
semanticscholar +1 more source
Journal of Applied Clinical Medical Physics, EarlyView.Abstract This study compared three Brainlab thermoplastic masks—Cranial 4pi basic, stereotactic (Close Mask V2), and open‐face—to see how well they limited head movement during Stereotactic Radiosurgery (SRS). Using a head phantom, we tested rotational movements (pitch, yaw, and roll) and measured displacements with the ExacTrac system.
Iris Pasion Apale +2 more
wiley +1 more source
3D Printing of Multilayered and Multimaterial Electronics: A Review
Advanced Electronic Materials, 2021 3D printing, also known as additive manufacturing, is a manufacturing process in which the materials are deposited layer by layer in an additive manner.
G. L. Goh +3 more
semanticscholar +1 more source
3D-Printing for Analytical Ultracentrifugation
PLOS ONE, 2016 25 pages, 6 ...
Abhiksha Desai +4 more
openaire +5 more sources
Monte Carlo modeling of radiation dose from radiation therapy with superficial x‐rays
Journal of Applied Clinical Medical Physics, EarlyView.Abstract Introduction Superficial x‐rays (50–100 kVp) are used for treating non‐melanoma skin cancer and intraoperative radiation therapy (IORT). At these energies, the photoelectric effect significantly increases absorbed dose to bone compared to soft tissue.
Reham Barghash +3 more
wiley +1 more source
Virtual and Physical Prototyping, 2020 Three-dimensional (3D) printed Sc-modified Al alloy by powder bed fusion (PBF) provides significant strength and ductility without hot tearing during the process.
C. N. Kuo +6 more
doaj +1 more source
Journal of Applied Clinical Medical Physics, EarlyView.Abstract Purpose This study evaluates the dosimetric and geometric precision of a virtual cone technique using CBCT‐based polymer gel dosimetry, enabling radiation delivery, and imaging readout within an identical spatial coordinate system. Methods We created a C# script for a virtual cone technique that generates a treatment plan with 10 gantry arcs ...
Tenzin Kunkyab +6 more
wiley +1 more source