Results 81 to 90 of about 10,392 (215)
ABSTRACT Introduction The proliferation of inaccurate information about tooth bleaching on the internet poses a growing risk to oral health, promoting potentially harmful practices while undermining evidence‐based professional guidance. Objective Evaluate the quality, reliability, and educational impact of tooth bleaching videos on YouTube ...
Letícia de Azevedo Lima Silva +4 more
wiley +1 more source
Abstract The objectives of this study are to evaluate, in vitro, the microhardness, sorption, solubility, color stability, and color‐matching ability of monochromatic resin composites: Palfique Omnichroma / Tokuyama (Mono1) and Vittra APS Unique / FGM (Mono2) compared with the conventional resin composite: Filtek Z250 XT / Solventum (Conv).
Ericka dos Santos Lopes +5 more
wiley +1 more source
Abstract This study evaluated the influence of printing orientation and post‐curing on the color stability, gloss retention, and surface microhardness of a definitive three‐dimensional (3D)‐printed dental resin, a high‐strength photopolymer with inorganic fillers designed for permanent restorations, after immersion in a staining solution.
Luana dos Santos Souza +4 more
wiley +1 more source
CLINICAL CASES OF RECOVERY TECHNOLOGY GENTLE BITE HEIGHT IN PATHOLOGICAL ABRASION
The abstract. In pathological abrasion of teeth doctor before the problem arises not only recover lost hard tissue of teeth, and keep and received the maximum height for a long period of time.
R.V. Kozak
doaj
Abstract Hydrogen peroxide (HP) at 35% is effective for dental bleaching but may reduce enamel mineral content and induce structural changes. This study developed a bleaching‐hydrogel containing 6%HP and manganese‐oxide–doped Biosilicate (MnO_BioS), activated by violet LED, under in situ conditions.
Rafael Dascanio +5 more
wiley +1 more source
Abstract This study evaluated the mechanical performance and staining resistance of a three‐dimensional (3D)‐printed resin (VarseoSmile Crown Plus) subjected to different post‐curing times (0, 5, 10, 15, and 20 min), compared with a conventional nanofilled resin composite (Filtek Z350XT).
Bianca Rossi +6 more
wiley +1 more source
Abstract This study evaluated (1) the load‐bearing capacity of molars restored with direct occlusal veneers fabricated either from short‐fiber‐reinforced composite (SFRC) or particulate‐filled composite (PFC) and the presence of internal voids within the materials, and (2) effect of water storage on the fracture load and correlation between internal ...
Topias Yli‐Urpo +6 more
wiley +1 more source
Abstract Rubbing phosphoric acid during etching has been shown to improve surface roughness in prepared enamel. This study aimed to compare intact enamel's surface roughness and resin tag lengths after etching with and without rubbing. Extracted sound third molars were used for testing, mesially for conventional and distally for dynamic (rubbing ...
Moana Biedermann +5 more
wiley +1 more source
The global prevalence of tooth wear in general population: a systematic review and meta-analysis
Objective: Tooth wear (TW), as a common dental challenge, refers to the loss of dental tissue with four types of Attrition, Erosion, Abrasion, and Abfraction.
Nader Salari +6 more
doaj +1 more source
A Systematic Review Evaluating Methods for Diagnosis, Treatment and Prevention of Dental Erosions
ABSTRACT Aim The aim of this systematic review was to investigate the quality of evidence for methods used to diagnose, restore and prevent dental erosions, by evaluating and summarising clinical controlled studies and in situ studies covering this field.
Maria Skalsky Jarkander +5 more
wiley +1 more source

