Results 131 to 140 of about 2,570,544 (382)
Advanced Engineering Materials, EarlyView.The share of technical thermoplastics is expected to grow further in the e‐mobility segment. In this study, a detailed temperature‐based tribological characterization of technical thermoplastics is performed. The tribological properties are discussed in terms of the dynamic mechanical properties of polymers at different ambient temperatures. A proof of
Harsha Raghuram +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk +4 more
wiley +1 more source
NanomaterialsNanomaterials are integrated within consumer products to enhance specific properties of interest. Their release throughout the lifecycle of nano-enabled products raises concerns; specifically, mechanical strains can lead to the generation of fragmented ...
Amaia Soto Beobide +8 more
doaj +1 more source
Erosion-corrosion behaviour of Zirconia WC-6Co, WC-6Ni and SS316 [PDF]
, 2015 The current study investigates a ceramic, two cermets and a metal under solid-liquid impingement with 3.5% NaCl and 150mg/l hydraulic fracturing sand at two extreme angles of impact, 90° and 20°.
Andrews, N. +3 more
core
Influence of oxide films on primary water stress corrosion cracking initiation of alloy 600 [PDF]
, 2006 In the present study alloy 600 was tested in simulated pressurised water reactor (PWR) primary water, at 360 °C, under an hydrogen partial pressure of 30 kPa. These testing conditions correspond to the maximum sensitivity of alloy 600 to crack initiation.
Andrieu, Eric +5 more
core +1 more source
Additive Manufacturing of Highly Alloyed Aluminum–Lithium
Advanced Engineering Materials, EarlyView.Al–Li alloys, promising for future lightweight constructions due to their low density and high stiffness, are limited to 9 at% lithium in commercial forms because of segregation issues. To overcome this traditional limitation, powder bed fusion with an ultrashort pulse laser is used.
Lisa Matthäus +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing technologies like laser powder‐bed fusion offer great design freedom and individualization of products down to a batch size of one. However, parts fabricated with this technology suffer from poor quality. Acoustic assistance during the build process can minimize these drawbacks.
Oliver Maurer, Dirk Bähre
wiley +1 more source
The Analysis of the Cutting Forces and Surface Layer Stereometry in the Grinding Process of Abrasion-Resisting Materials [PDF]
, 2016 The article presents the investigation of the grinding process of flat samples made of materials that meet requirements of the lowest abrasibility, which belong to difficult to machine materials.
Grdulska, Anna +3 more
core
Advanced Engineering Materials, EarlyView.Prestraining the substrate influences coating formation process. Higher prestraining force leads to higher coating thickness and lower hardness. Increase in prestraining force enhances preliminary damage in hard anodic coating. Fatigue damage mechanisms change for hard anodized prestrained samples.
Linto George Thomas +4 more
wiley +1 more source
Effect of Abrasive Particles on Frictional Force and Abrasion in Chemical Mechanical Polishing(CMP) [PDF]
, 2004 Goo-Youn Kim +5 more
openalex +1 more source