Results 91 to 100 of about 62,159 (212)
Abrasive Flow Machining using Abrasive Paste with Oiticica Oil [PDF]
International Journal of Advanced Engineering Research and Science, 2019 Marcelo Rodrigo Munhoz +4 more
openaire +1 more source
Optimization of Cutting Process of Medium Density Fibreboards by the Abrasive Water-Jet
Drvna Industrija, 2011 This paper deals with the process of MDF cutting by the abrasive water-jet (WJC) and shows how is kerf width infl uenced by process parameters. It presents the results of monitoring the kerf width related to technical and technological parameters ...
Štefan Barcík +3 more
doaj
The friction and wear of metals and binary alloys in contact with an abrasive grit of single-crystal silicon carbide [PDF]
Sliding friction experiments were conducted with various metals and iron-base binary alloys (alloying elements Ti, Cr, Mn, Ni, Rh and W) in contact with single crystal silicon carbide riders.
Buckley, D. H., Miyoshi, K.
core +1 more source
Cost/benefit studies of advanced materials technologies for future aircraft turbine engines: Materials for advanced turbine engines [PDF]
Cost benefit studies were conducted on six advanced materials and processes technologies applicable to commercial engines planned for production in the 1985 to 1990 time frame.
Stearns, M., Wilbers, L.
core +1 more source
, 2017 We consider a nanomachining process of hard, abrasive particles grinding on the rough surface of a polycrystalline ferritic work piece. Using extensive large-scale molecular dynamics (MD) simulations, we show that the mode of thermostatting, i.e., the ...
Betz, Gerhard +4 more
core +1 more source
RELIABILITY CONTROL OF PRODUCTION PROCESSES OF CENTRIFUGAL ROTATORY TREATMENT BY LOOSE ABRASIVE
Вестник Донского государственного технического университета, 2018 Some probability-theoretical models of the metal removal and the formation of the surface coating condition under the loose-abrasive machining are improved.
Yury V. Korolkov
doaj
Large area Czochralski silicon [PDF]
The overall cost effectiveness of the Czochralski process for producing large-area silicon was determined. The feasibility of growing several 12 cm diameter crystals sequentially at 12 cm/h during a furnace run and the subsequent slicing of the ingot ...
Gleim, P. S., Rea, S. N.
core +1 more source
Optimal control of the heave motion of marine cable subsea-unit systems [PDF]
, 1995 One of the key problems associated with subsea operations involving tethered subsea units is the motions of support vessels on the ocean surface which can be transmitted to the subsea unit through the cable and increase the tension.
Huang, S., Vassalos, D.
core
Journal of Marine Science and EngineeringA supercritical suspended abrasive water jet with dual inputs of pressure and heat is proposed to improve the cutting performance of the conventional suspended abrasive water jet in deep-sea environments.
Zhibo Li +4 more
doaj +1 more source
RELIABILITY CONTROL OF PRODUCTION PROCESSES OF CENTRIFUGAL ROTATORY TREATMENT BY LOOSE ABRASIVE
Advanced Engineering Research, 2011 Some probability-theoretical models of the metal removal and the formation of the surface coating condition under the loose-abrasive machining are improved.
Yury V. Korolkov
doaj