On Characterization of Shear Viscosity and Wall Slip for Concentrated Suspension Flows in Abrasive Flow Machining. [PDF]
Materials (Basel), 2023 Peng C, Gao H, Wang X.
europepmc +1 more source
Abrasive Water Jet Machining (AWJM) of Titanium Alloy—A Review
DesignsAbrasive water jet machining (AWJM) is a non-traditional machining process that is increasingly employed for shaping hard-to-machine materials, particularly titanium (Ti)-based alloys such as Ti-6Al-4V.
Aravinthan Arumugam +3 more
doaj +1 more source
Investigation of material removal in inner-jet electrochemical grinding of GH4169 alloy
Scientific Reports, 2017 Electrochemical grinding (ECG) is a low-cost and highly efficient process for application to difficult-to-machine materials. In this process, the electrolyte supply mode directly affects machining stability and efficiency.
Hansong Li +4 more
doaj +1 more source
Prediction of Surface Roughness in Gas-Solid Two-Phase Abrasive Flow Machining Based on Multivariate Linear Equation. [PDF]
Micromachines (Basel), 2022 Wang W +6 more
europepmc +1 more source
Wear characterization of cemented carbides (WC-CoNi) processed by laser surface texturing under abrasive machining conditions [PDF]
, 2017 Cemented carbides are outstanding engineering materials widely used in quite demanding material removal applications. In this study, laser surface texturing is implemented for enhancing, at the surface level, the intrinsic bulk-like tribological ...
Bähre, Dirk +2 more
core +3 more sources
Experimental studies using minimum quantity cooling (MQC) with molybdenum disulfide and graphite-based microfluids in grinding of Inconel® alloy 718 [PDF]
, 2019 In the paper, the results of experimental studies related with determination of the influence of the supply of a grinding fluid (GF) doped with powdered graphite and MoS2 into the machining zone with the minimum quantity cooling (MQC) method on the ...
Kapłonek, Wojciech +5 more
core +1 more source
Analysis on mechanism of material removal rate and surface flow machining process [PDF]
MATEC Web of ConferencesA novel finishing technique called abrasive flow machining (AFM) uses abrasive particles as the instrument for material removal. The term "self-deformable stone" refers to the abrasive particle-containing carrier medium, and AFM is commonly known as "no ...
Kondala Rao Peram, Ranga Janardhana G.
doaj +1 more source
Fabrication of abrasive jet machine [PDF]
, 2013 Abrasive Jet Machining (AJM) is the process of material removal from a work piece by the application of a high speed stream of abrasive particles suspended in a gas medium from a nozzle.
Biswal, Shatabdi
core
Multi Objective Optimisation of Build Orientation for Rapid Prototyping with Fused Deposition Modeling (FDM) [PDF]
, 2007 The ability to select the optimal orientation of build up is one of the critical factors since it affects the part surface quality, accuracy, build time and part cost.
Anjikar, Swapnil D. +2 more
core +1 more source
Machining and grinding of ultrahigh-strength steels and stainless steel alloys [PDF]
Machining and grinding of ultrahigh-strength steels and stainless steel ...
Boulger, F. W. +2 more
core +1 more source