Results 101 to 110 of about 16,253 (207)
Predictive model for polishing times in mould finishing [PDF]
, 2013 El pulido, proceso final utilizado en la producción de piezas, es a menudo lento y se aplica manualmente. Normalmente define la rugosidad superficial y la precisión de la pieza.
González Rojas, Hernan Alberto +4 more
core
Electricity from photovoltaic solar cells: Flat-Plate Solar Array Project final Report. Volume III: Silicon sheet: wafers and ribbons [PDF]
, 1986 The Flat-Plate Solar Array (FSA) Project, funded by the U.S. Government and managed by the Jet Propulsion Laboratory, was formed in 1975 to develop the module/array technology needed to attain widespread terrestrial use of photovoltaics by 1985.
Briglio, A. +3 more
core
Machinery, equipment and tools: A compilation [PDF]
A selection of new hand tools, modifications of existing tools, and techniques developed in the course of NASA research and development project is presented.
core +1 more source
Meitan xuebaoAbrasive water jet is a highly efficient cutting technology. Through some sandstone cutting tests, the research on the optimal impact angle and inclined cutting mechanism of rock-like materials is carried out.
Ruifu YUAN +6 more
doaj +1 more source
Investigation of surface adhesion produced by high-speed flame spraying [PDF]
, 2007 Peculiarities of surface adhesion based on nickel, produced by high-velocity spraying on steel base with different surface morphology have been analysed.
Klimenov, V. А. +3 more
core
Hydration-assisted Ultrasonic Abrasive Flow Polishing Technology on Sapphire Microcavity
DEStech Transactions on Computer Science and Engineering, 2019 Xiao-bing LIU, Lin MA
openaire +2 more sources
Tribological properties of structural ceramics [PDF]
The tribological and lubricated behavior of both oxide and nonoxide ceramics are reviewed in this chapter. Ceramics are examined in contact with themselves, other harder materials and metals.
Buckley, D. H., Miyoshi, K.
core +1 more source
Experimental of Abrasive Flow Machining on P20 Surface Mold Polishing
Experimental of Abrasive Flow Machining on P20 Surface Mold PolishingThe paper presents the effect of the clearanceof specimens and tools for surface roughness (Ra) of P20 mold steel that is related to abrasive flow machining (AFM). This study experimented with flat specimens. AFM experiments are performed to identify the improved surface roughness when applied to the polishing specimens.
openaire
Carbide Twist Drill Spiral Groove Abrasive Flow Polishing and Abrasive Flow Analysis
Manufacturing TechnologyTian Ji +4 more
openaire +1 more source
How to evaluate solid lubricant films using a pin-on-disk tribometer [PDF]
Over the years, the author has evaluated and compared hundreds of solid lubricant films using a pin-on-disk tribometer. The intent of this paper is to describe to the reader experimental techniques and some of parameters that have been observed to be ...
Fusaro, R. L.
core +1 more source