Results 161 to 170 of about 16,278 (306)
steel research international, EarlyView.This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam +7 more
wiley +1 more source
steel research international, EarlyView.The study investigates the influence of DED‐Arc/M versus casting on the microstructure and material properties of X40CrMoV5‐1 (AISI H13) hot‐work tool steel. DED‐Arc/M yields finer microstructures, superior mechanical strength, and ductility, but slightly reduced thermal conductivity.
Ulf Ziesing +4 more
wiley +1 more source
Major Reference Works, Page 290-301., 2021 International Tables for Crystallography is the definitive resource and reference work for crystallography and structural science.
Each of the eight volumes in the series contains articles and tables of data relevant to crystallographic research and to applications of crystallographic methods in all sciences concerned with the ...
John P. Sutter C. Chantler +2 more
wiley +1 more source
steel research international, EarlyView.Tool steels tested under injection molding conditions with glass‐fiber‐reinforced polymers, revealing how viscous dissipation drives hardness loss, even in PM grades. A sharp rise in wear with increasing injection volume rate and thermomechanical load uncovers striking material differences.
David Zidar +3 more
wiley +1 more source
steel research international, EarlyView.The studied X65MoCrWV3‐2 press hardening tool steel, produced via laser‐based direct energy deposition DED‐LB/M, exhibits a 15‐20% lower thermal conductivity than its conventionally produced equivalent when heat‐treated to operational hardness. The microstructural evolution during the employed direct tempering leads to anisotropic thermal transport, as
Julia Hahn +3 more
wiley +1 more source
National Educators' Workshop: Update 1988. Standard Experiments in Engineering Materials Science and Technology [PDF]
Presented here is a collection of experiments presented and demonstrated at the National Educators' Workshop: Update 88, held May 10 to 12, 1988 at the National Institute of Standards and Technology (NIST), Gaithersberg, Maryland.
Gardner, James E., Jacobs, James A.
core +1 more source
steel research international, EarlyView.The study evaluates mill scale‐based briquettes, which meet industrial standards for shatter strength and exhibit a low decrepitation index. Despite their limited reducibility in nonisothermal reduction experiments, softening and melting results indicate potential application as a substitute for conventional acidic iron‐bearing materials for use in ...
Ismael Vemdrame Flores +4 more
wiley +1 more source
Carbide Twist Drill Spiral Groove Abrasive Flow Polishing and Abrasive Flow Analysis
Manufacturing TechnologyTian Ji +4 more
openaire +1 more source
Advancing Model‐Based Systems Engineering in the Development of Naval Vessel Systems Architecture
Systems Engineering, EarlyView.ABSTRACT The increasing complexity of modern naval vessels due to technological advancements poses challenges for early‐stage ship design (ESSD). Developing well‐defined system architectures and adopting systems engineering approaches are essential to address these challenges.
Vasileios Sideris +3 more
wiley +1 more source
How to evaluate solid lubricant films using a pin-on-disk tribometer [PDF]
Over the years, the author has evaluated and compared hundreds of solid lubricant films using a pin-on-disk tribometer. The intent of this paper is to describe to the reader experimental techniques and some of parameters that have been observed to be ...
Fusaro, R. L.
core +1 more source