Results 101 to 110 of about 4,616,768 (322)
The determination of par levels from absorption coefficient profiles at 490 nm
Ciencias Marinas, 1999 A model is presented that allows the prediction of percent photosynthetically available radiation (PAR) levels from measured profiles of the absorption coefficient at 490 nm in the Gulf of California. Percent PAR levels depend on the diffuse attenuation
AH Barnard +8 more
doaj +1 more source
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
Advanced Engineering Materials, EarlyView.The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
Linearity of calibration curves: use and misuse of the correlation coefficient. [PDF]
correlation coefficient is commonly used to evaluate the degree of linear association between two variables. However, it can be shown that a correlation coefficient very close to one might also be obtained for a clear curved relationship.
Beernaert, H +3 more
core
, 2008 Intensity-dependent enhancement of saturable absorption in a film of PbS-Au4 nanohybrid composites has been observed by femtosecond time-resolved transient absorption measurement at 780 nm.
Hendry I. Elim +4 more
core +1 more source
Absorption Coefficient of Molten Aluminum Oxide in Semitransparent Spectral Range
, 2013 A critical compilation and analysis of all the available experimental data and approximation formulas for the wavelength and temperature dependences of the absorption coefficient of molten aluminum oxide in semitransparent region are presented.
V. K. Bityukov, V. Petrov
semanticscholar +1 more source
Measuring pure water absorption coefficient in the near-infrared spectrum（900—2500 nm）
National Remote Sensing Bulletin, 2012 According to the extreme large and mutable characteristics of water absorption coefficient in the infrared spectrum,a device for measuring thin thickness of water layer is developed on the basis of the previously presented system for measuring water ...
Chen Lei
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Evaluation of pH and Optical Properties of Dual Rinse HEDP Irrigating Solution
Applied SciencesThis study investigates the pH values and optical characteristics of Dual Rinse HEDP, either independently or combined with sodium hypochlorite (NaOCl), and compares them to other irrigants used in endodontics.
Andjelka Simic +8 more
doaj +1 more source
, 2014 Citation: 'molar absorption coefficient' in the IUPAC Compendium of Chemical Terminology, 3rd ed.; International Union of Pure and Applied Chemistry; 2006. Online version 3.0.1, 2019. 10.1351/goldbook.M03972 • License: The IUPAC Gold Book is licensed under Creative Commons Attribution-ShareAlike CC BY-SA 4.0 International for individual terms. Requests
openaire +1 more source
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source