Results 211 to 220 of about 20,427 (306)

Dental Implants in Adults With Intellectual Disabilities: A Multicenter Retrospective Study. Part 2: Prosthesis Outcomes

open access: yesJournal of Oral Rehabilitation, EarlyView.
This multicenter retrospective study evaluated the long‐term outcomes of implant‐supported prostheses in adults with non‐syndromic intellectual disabilities. Among 247 prostheses with a mean follow‐up of 68 months, prosthetic survival reached 97% at 5 years and 85% at 15 years. These findings demonstrate that implant‐supported prosthetic rehabilitation
Javier Fernández‐Feijoo   +19 more
wiley   +1 more source

Effect of build orientation on the fabrication trueness of additively manufactured implant‐supported complete arch interim fixed prostheses

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To evaluate how build orientation affects the fabrication trueness of additively manufactured implant‐supported complete arch prostheses by comparing them to subtractively manufactured high‐impact polymer‐based prostheses. Materials and Methods An edentulous maxillary model with four implants at canine and first molar regions ...
Amir H. Nejat   +4 more
wiley   +1 more source

The effects of anodization and instrumentation on titanium abutment surface characteristics and biofilm formation

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To assess the impact of anodization and instrumentation on titanium abutment surface characteristics (surface roughness and wettability) and biofilm formation (viability and mass). Materials and Methods Titanium discs were obtained from pre‐milled abutment blanks made of titanium‐6aluminum‐7niobium alloy.
Weiqing Liu   +4 more
wiley   +1 more source

Marginal gap of printed, milled, and heat‐pressed two‐piece polyetheretherketone abutments before and after thermal cycling, and their pull‐off bond strength after thermal cycling

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To evaluate the marginal gap of two‐piece polyetheretherketone (PEEK) abutments fabricated with different methods, before and after thermal cycling, while also focusing on their pull‐off bond strength. Materials and Methods A two‐piece abutment was virtually designed after digitizing a titanium‐base (Ti‐base) abutment.
Almira Ada Diken Türksayar   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy