Results 131 to 140 of about 571 (248)

Parameter identification of PLL for grid‐connected inverter based on parameter sensitivity analysis

IET Power Electronics
Under the condition of weak grid, the phase‐locked loop (PLL) is one of the main reasons for the sub‐synchronous oscillation of the grid‐connected inverter.
Fei Li, Qiang Feng, Ping Chen, Yang Liu, Shuiliang Cai, Hanyu Wang, Xing Zhang   +6 more
doaj   +1 more source

Syngas Production for Fischer-Tropsch Synthesis from Rubber Wood Pellets and Eucalyptus Wood Chips in a Pilot Horizontal Gasifier with CaO as a Tar Removal Catalyst. [PDF]

ACS Omega, 2022
Slatter NL, Vichanpol B, Natakaranakul J, Wattanavichien K, Suchamalawong P, Hashimoto K, Tsubaki N, Vitidsant T, Charusiri W.   +8 more
europepmc   +1 more source

Cornus Mas L. Seed‐Derived Biosorbent for Methylene Blue Removal: Surface Characterization and Biosorption Performance

Advanced Materials Interfaces, EarlyView.
Cornus mas L. seeds are transformed into a high‐performance biosorbent through chemical modification, effectively removing methylene blue from aqueous solutions. Comprehensive characterization and optimization reveal a maximum biosorption capacity of 71.71 mg g−1, establishing this sustainable, cost‐effective material as a promising solution for ...
Hakan Yıldız, Adem Necip, Arslan Yusuf Yüksel   +2 more
wiley   +1 more source

Methods for the calibration of bone conduction transducers at frequencies from 5 to 20 kHz. [PDF]

J Acoust Soc Am, 2022
Remenschneider AK, Cheng JT, Rosowski JJ.   +2 more
europepmc   +1 more source

Ti3C2Tx MXene/Silver Composite Foams For Lightweight, High‐Performance Electromagnetic Interference Shielding and Joule Heating

Advanced Materials Interfaces, EarlyView.
Ultrathin MXene/EMF composite foams achieve a specific shielding efficiency of 749.6 dB.dB·cm3$\mathrm{dB}\cdot {\mathrm{cm}}^{3}$/g, while the silver‐enhanced MXene/Ag/EMF reaches 81.4 dB shielding effectiveness at just 1.0 mm thickness. Both composites exhibit rapid Joule heating, retain stability up to 250∘C$^\circ{\rm C}$, and withstand 1000 ...
Abdullah A. Mahmood, Mingxuan Li, Vahid Rad, Mehdi Zarei, Chen‐Yu Yeh, Masoud Soroush, Guangyong Li, Paul W. Leu   +7 more
wiley   +1 more source

Piezoelectric Energy Harvesting Solutions: A Review. [PDF]

Sensors (Basel), 2020
Covaci C, Gontean A.
europepmc   +1 more source

Gas‐Selective Remote Plasma Engineering of WO3 Photoanodes for Solar Water Splitting

Advanced Materials Interfaces, EarlyView.
Gas‐selective remote plasma treatment tunes the near‐surface defect chemistry of WO3 photoanodes without altering their bulk structure. Ar plasma generates the most oxygen‐vacancy‐rich surface and the highest W5+ content, delivering the strongest photocurrent.
Elham Jassemi Zargani, Amar K. Salih, Salma M. Ali, Hongjun Chen, Antonio Tricoli, Cuong Ton‐That   +5 more
wiley   +1 more source

The natural history study of preclinical genetic Creutzfeldt-Jakob Disease (CJD): a prospective longitudinal study protocol. [PDF]

BMC Neurol, 2023
Bregman N, Shiner T, Kavé G, Alcalay R, Gana-Weisz M, Goldstein O, Glinka T, Aizenstein O, Bashat DB, Alcalay Y, Mirelman A, Thaler A, Giladi N, Omer N.   +13 more
europepmc   +1 more source

Facet‐Specific PbS Quantum Dot Passivation Using Halide Perovskites for SWIR Photodetectors

Advanced Materials Interfaces, EarlyView.
PbS quantum dots (QDs) are emerging as powerful short‐wave infrared photodetectors, yet the passivation mechanism of large QDs by perovskites ‐ critical for their stability ‐ remains unexplained. Here, we unveil the ligand structure of CH3NH3PbI3 (MAPI)‐passivated 4‐nm PbS QDs using FTIR, XPS, SEM, NMR, and DFT.
L. Paillardet, M. Gromova, D. Liu, A. S. Vasenko, O. V. Prezhdo, S. Alarab, G. De Paëpe, G. Lefevre, S. Charlot, O. Gourhant, B. Mortini, P. Reiss, J.‐M. Verilhac, D. Aldakov   +13 more
wiley   +1 more source

Light Switchable Ionic Conductivity of Arylazopyrazole Modified Polysiloxanes

Advanced Materials Technologies, EarlyView.
We present a polysiloxane functionalized with a novel arylazopyrazole dye that undergoes reversible photoisomerization. Upon lithium bis(trifluoromethanesulfonyl)imide addition and UV irradiation, the polymer exhibits a shift in tan(d) toward higher frequencies and enhanced ionic conductivity.
Malte S. Beccard, Thulasinath Raman Venkatesan, Michael Bauer, Valentin Razvan Lupu, Philipp Scheidegger, Francesco Taddei, Frank A. Nüesch, Dorina M. Opris   +7 more
wiley   +1 more source