Results 91 to 100 of about 1,172,822 (240)
Metals, 2019 In this study, selective laser melting (SLM) Ti-6Al-4V is subjected to heat treatment for 4 h at 400 °C, 600 °C, and 800 °C, followed by air cooling.
Jun-Ren Zhao +3 more
doaj +1 more source
Experimental Validation of External Load Effects for Micro-Contacts under Low Frequency, Low Amplitude Alternating Current (AC) Test Conditions [PDF]
, 2018 The use of micro-contacts has been demonstrated in various radio frequency (RF) applications. However, the premature failure of such devices under alternating current (AC) operations is still a hurdle to further development.
Coutu, Ronald A., Jr. +2 more
core +1 more source
Inductance and resistance calculations for isolated conductors
, 2005 In this review paper we present various analytical and numerical calculations for computing the high frequency and low frequency inductance and resistance of isolated conductors.
Goddard, K.F., Roy, A.A., Sykulski, J.K.
core +1 more source
Electrical Conductivities of Conductors, Semiconductors, and Their Mixtures at Elevated Temperatures
Advanced Engineering Materials, EarlyView.This article presents a comprehensive review of temperature‐dependent electrical conductivity data for multiple material classes at elevated temperatures, highlighting a persistent conductivity gap between metals and semiconductors in the range of 102$\left(10\right)^{2}$– 107$\left(10\right)^{7}$ S/m. Metal–ceramic irregular metamaterials are proposed
Valentina Torres Nieto, Marcia A. Cooper
wiley +1 more source
InfrastructuresA recently used material that shows environmental and technical advantages for use as an asphalt binder modifier is biochar (BC). Different biomasses can be converted into BC by pyrolysis.
Saieth Baudilio Chaves-Pabón +2 more
doaj +1 more source
Mixed state Hall effect in the multiphase superconductors
, 2002 Hall effect below Tc in multiphase superconductors has been studied on Bi-based superconductors. Samples with different relative content of 2212 and 2223 phase have been prepared. The phase content has been verified by X-ray diffraction.
Bardeen +21 more
core +1 more source
Cored Rutherford cables for the GSI fast ramping synchrotron [PDF]
, 2002 The new heavy ion synchrotron facility proposed by GSI will have two superconducting magnet rings in the same tunnel, with rigidities of 200 T/spl middot/m and 100 T/spl middot/m.
Ghosh, A.K. +10 more
core +4 more sources
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Frequency and Voltage Dependence of Series Resistance in a Solar Cell [PDF]
, 2016 While admittance measurements of solar cells are typically conducted in reverse or at zero bias, and analyzed using the depletion approximation, the operating point of the solar cell is in forward bias, and the series resistance is often estimated using ...
Cox, Thaddeus J. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi +7 more
wiley +1 more source