Results 41 to 50 of about 331,297 (255)
Acetaldehyde concentrations in alveolar air following a standard dose of ethanol in man
A method for serial gas chromatographic determinations of acetaldehyde, acetone, and ethanol in alveolar air is described. The concentration of alcohol in alveolar air increased rapidly and then declined linearly following ingestion of ethanol, 0.5 ml/lb
Gerhard Freund, Paul O'Hollaren
doaj +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Objective:In this study, the effects of different chemical solvents such as acetone, ethanol, dimethyl sulfoxide (DMSO), peppermint oil, and hot water on the shear bond strength (SBS) of mechanically and chemically bonded ceramic brackets were examined ...
Hande Uzunçıbuk +1 more
doaj +1 more source
Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
The aim of this work was the study a trickling biofilter, where water was circulated throughout the bed. In the first steady state experiment, the packing materials used were 25mm Pall rings. The airflow rate was increased gradually and the concentration
Andrew Mark Gerrard +6 more
doaj +1 more source
Deep‐UV (258 nm) femtosecond pulses enable uniform amorphous silicon writing on Si(100)/(111) with a six‐fold larger fluence amorphization window than NIR methods. Optimized fluence and overlap yield 20–45 nm uniform and continuous amorphous layers. Microscopy shows sharp interfaces, and real‐time reflectivity reveals nanosecond melt–resolidification ...
Wissal Benali +5 more
wiley +1 more source
The inclusion of carbon nanotubes (CNTs) in cementitious composites has been studied due to their electrical, thermal, and mechanical enhancing properties. Considering the hydrophobic characteristics of CNTs, these nanomaterials need to be well dispersed
Vanessa Vilela Rocha +3 more
doaj +1 more source
Counterion Dependent Side‐Chain Relaxation Stiffens a Chemically Doped Thienothiophene Copolymer
Oxidation of a thienothiophene copolymer, p(g3TT‐T2), via different doping strategies and dopant molecules resulted in materials with similar oxidation levels and a high electrical conductivity of ≈100 S cm−1. However, mechanical properties varied significantly, with sub‐glass transition temperatures and elastic moduli spanning from –44°C to –3°C and ...
Mariavittoria Craighero +12 more
wiley +1 more source
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa +19 more
wiley +1 more source
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source

