Results 81 to 90 of about 411,268 (285)
Acetone Annex gantry from Furnace House, Lane Cove
, 2023 Item 3643 includes photographs of the Commonwealth Government Acetone Annex, Lane Cove. The factory was erected for the Ministry of Munitions by Acetone Pty. Ltd. Erection of the factory commenced in December 1941 and the factory went into production 15
Photographer: Unknown +1 more
core
Advanced Functional Materials, EarlyView.A dynamically actuated reconfigurable topographical surface (DARTS) integrates contact‐mediated bactericidal nanotopography with programmable mechanical actuation to actively disrupt bacterial biofilms. Dynamic surface reconfiguration enhances bacterial killing and suppresses implant‐associated infections in vivo, providing a new strategy for active ...
Mohammad Asadi Tokmedash +4 more
wiley +1 more source
, 2023 Raw, unprocessed NMR spectra obtained in d ...
Inigo J. Vitorica-Yrezebal (10985142) +7 more
core +1 more source
Bone‐Inspired Recyclable Composites for Damage‐Tolerant Circular Materials
Advanced Functional Materials, EarlyView.Bone‐inspired architected composites are developed by combining osteon‐like reinforcements with a recyclable Elium thermoplastic matrix. The hierarchical architecture redirects cracks and promotes energy dissipation, while enabling recovery of intact, aligned, load‐bearing reinforcement units that retain their original stiffness, revealing a route ...
Alessandro Stagni +4 more
wiley +1 more source
Bio‐Inspired Artificial Ionic Mechanoreceptor
Advanced Functional Materials, EarlyView.A skin‐inspired artificial mechanoreceptor based on ionic interactions is presented for biomimetic tactile sensing. Pressure‐driven ionic redistribution within microfluidic channels generates a self‐powered electrical signal without external bias. The generated waveform exhibits mechanoreceptor‐like temporal features, including overshoot and undershoot,
Mohammad Akbari +4 more
wiley +1 more source
, 2011 It has been shown that dry powder inhaler (DPI) formulations typically achieve low fine particle fractions (poor performance). A commonly held theory is that this is due, at least in part, to low levels of detachment of drug from lactose during ...
Waseem Kaialy +7 more
core +1 more source
Viscosities and refractive indices of binary systems acetone+1-propanol, acetone+1,2-propanediol and acetone+1,3-propanediol [PDF]
, 2014 Viscosities and refractive indices of three binary systems, acetone+1-propanol, acetone+1,2-propanediol and acetone+1,3-propanediol, were measured at eight temperatures (288.15, 293.15, 298.15, 303.15, 308.15, 313.15, 318.15, 323.15)K and at ...
Šerbanović Slobodan P. +7 more
core +2 more sources
Dirac‐Source Linear X‐Ray Detection Diode
Advanced Functional Materials, EarlyView.Monolayer graphene imparts near linear current‐voltage behavior to a perovskite X‐ray detection diode, contrasting with conventional diode‐like responses. Exploiting graphene's Dirac dispersion and a Schottky‐like back‐to‐back junction, the device achieves six‐orders‐of‐magnitude dark current suppression while retaining linearity over 200 V, enabling ...
Babar Shabbir +8 more
wiley +1 more source
Gas-phase ketonization of acetic acid over Co–Mo and its supported catalysts
Journal of Taibah University for Science, 2018 Ketonization of acetic acid was carried out in the gas phase over bulk and supported cobalt–molybdenum catalysts using a fixed-bed reactor. The conditions of the reaction were: 0.2 g of catalyst, 200–400°C, 1 bar pressure, 2 vol% of acetic acid and 20 mL
Hossein Bayahia
doaj +1 more source
Catalytic combustion of dilute acetone over Cu-doped ceria catalysts
, 2009 CuxCe1?xOy (x = 0.06, 0.13, and 0.23) were prepared by a solution combustion route using glycine as the fuel and tested for the catalytic combustion of dilute acetone in air.
Hu, Chaoquan +14 more
core +1 more source