Results 11 to 20 of about 71 (54)

Resistência de união à microtração de sistemas adesivos “condiciona-e-lava” de dois passos: efeito de diferentes tratamentos da superfície dentinária condicionada

Revista de Odontologia da UNESP, 2017
Resumo Introdução A evolução dos sistemas adesivos permitiu que os fabricantes desenvolvessem materiais com técnicas cada vez mais simplificadas, porém que, ainda assim, promovessem adequados valores de resistência de união imediata.
Tamíris Pereira da Costa NEVES, Thais Piragine LEANDRIN, Mateus Rodrigues TONETTO, Marcelo Ferrarezi ANDRADE, Edson Alves de CAMPOS   +4 more
doaj   +1 more source

Influence of post-bleaching time intervals on dentin bond strength Influência de tempos de espera pós-clareamento na resistência adesiva da dentina

Brazilian Oral Research, 2004
It has been reported that bond strength of resin to tooth structure can be reduced when the bonding procedure is carried out immediately after the bleaching treatment. This study evaluated the effect of bleaching of non-vital teeth bleaching on the shear
Erica Cappelletto Nogueira Teixeira, Cecilia Pedroso Turssi, Anderson Takeo Hara, Mônica Campos Serra   +3 more
doaj   +1 more source

Effect of dentinal surface preparation on bond strength of self-etching adhesive systems Efeito da preparação da superfície dentinária na resistência de união de adesivos autocondicionantes

Brazilian Oral Research, 2006
The aim of this study was to evaluate the effects of dentin surface treatments on the tensile bond strength (TBS) of the self-etching primer Clearfil SE Bond (CSE) and the one-step self-etching One-Up Bond F (OUB).
Patrícia Itocazo Rocha, Alessandra Bühler Borges, José Roberto Rodrigues, César Augusto Galvão Arrais, Marcelo Giannini   +4 more
doaj   +1 more source

Bond strength of a composite resin to glass ionomer cements using different adhesive systems

Revista de Odontologia da UNESP, 2017
Introduction Glass ionomer cements are often used as a base or cavity lining prior to restorative material. Objective To evaluate the bond strength of a composite resin to different glass ionomer cements, when using a two-step conventional and self ...
Ana Carolina de Oliveira BECCI, Mônica de Souza BENETTI, Natália Bertolo DOMINGUES, Elisa Maria Aparecida GIRO   +3 more
doaj   +1 more source

Effect of 2% iodine disinfecting solution on bond strength to dentin Efeito da solução desinfetante de iodo a 2% sobre a adesão à dentina

Journal of Applied Oral Science, 2006
INTRODUCTION: Disinfection of dentin surfaces is desirable so long as it does not interfere with subsequent bonding of adhesive resins. OBJECTIVE: To test the null hypothesis that bond strengths to dentin are not affected by previous application of an ...
Nelson Renato Franca Alves da Silva, Christine S. Calamia, Paulo G. Coelho, Marcela Rocha de Oliveira Carrilho, Ricardo Marins de Carvalho, Page Caufield, Van P. Thompson   +6 more
doaj   +1 more source

Quantitative evaluation of microleakage in class V cavities using one-bottle and self-etching adhesive systems Avaliação quantitativa da microinfiltração em cavidades classe V utilizando sistemas adesivos de frasco único ou autocondicionante

Brazilian Oral Research, 2004
The aim of this in vitro study was to evaluate quantitatively the microleakage in class V cavities restored with one-bottle and self-etching adhesive systems with and without previous acid etching. Two one-bottle adhesive systems (Single Bond and Prime &
Fabiana Mantovani Gomes França, Flávio Henrique Baggio Aguiar, Alex José Souza dos Santos, José Roberto Lovadino   +3 more
doaj   +1 more source

One-bottle adhesives: in vitro analysis of solvent volatilization and sealing ability Adesivos de frasco único: análise in vitro da volatilização do solvente e do selamento marginal

Brazilian Oral Research, 2005
The aim of this study was to compare the solvent volatilization rate and evaluate the sealing ability of different one-bottle adhesives that were in constant clinical use - an ethanol/water-based adhesive (Single Bond, 3M/ESPE - SB) and an acetone-based ...
Fábio Garcia Lima, Rafael Ratto de Moraes, Flávio Fernando Demarco, Francisco Augusto Burkert Del Pino, John Powers   +4 more
doaj   +1 more source

The effect of insertion and photopolymerization techniques on microleakage of Class V cavities: a quantitative evaluation Efeito de diferentes técnicas de inserção e fotopolimerização na microinfiltração de cavidades Classe V: avaliação quantitativa

Brazilian Oral Research, 2005
The aim of this in vitro study was to evaluate by spectrophotometry the influence of the incremental technique and progressive light curing in the microleakage of Class V cavities.
Fabiana Mantovani Gomes França, Frederico Seidi Hori, Alex José Souza dos Santos, José Roberto Lovadino   +3 more
doaj   +1 more source

Bond strength of adhesive systems to human tooth enamel Resistência adesiva de sistemas adesivos ao esmalte dentário humano

Brazilian Oral Research, 2007
The purpose of this study was to evaluate in vitro three adhesive systems: a total etching single-component system (G1 Prime & Bond 2.1), a self-etching primer (G2 Clearfil SE Bond), and a self-etching adhesive (G3 One Up Bond F), through shear bond ...
Thaís Cachuté Paradella, Marcelo Fava
doaj   +1 more source

Effect of one-bottle adhesive systems on the fluoride release of a resin-modified glass ionomer Efeito dos sistemas adesivos de frasco único na liberação de flúor de um cimento de ionômero de vidro modificado por resina

Journal of Applied Oral Science, 2004
A dhesive systems associated to resin-modified glass ionomer cements are employed for the achievement of a higher bond strength to dentin. Despite this benefit, other properties should not be damaged.
Linda Wang, Marília Afonso Rabelo Buzalaf, Maria Teresa Atta   +2 more
doaj   +1 more source