Results 211 to 220 of about 120,520 (249)

Topical adhesive as a wound dressing for elective abdominal surgery: Response from the authors

, 2002
Neil Borley, N. J. Mortensen
openalex   +1 more source

Introduction series of polymer materials. 7. Coating and adhesive.

, 1985
Kazumune Nakao
openalex   +2 more sources

Tribology of ZrC Coatings and Spherical Tips Acquired with Extraordinarily Stiff, Metal Atomic Force Microscopy Probes

Advanced Engineering Materials, EarlyView.
In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk, Marcin Michałowski, Bogdan Warcholiński, Michał Milczarek, Adam Gilewicz   +4 more
wiley   +1 more source

Adhesive interactions between yeasts and bacteria on biomaterials surfaces

, 1999
Kevin W. Millsap
openalex   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

Advanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen, Benjamin Bohne, Sven Winter, Marcus Böhme, Martin F.-X. Wagner   +4 more
wiley   +1 more source

High-Performance Electrochemical Adhesives Enabled by Perfluorinated Sulfonic-Acid Ionomers with Precise Adhesion Control and Long-Term Switchability. [PDF]

Adv Sci (Weinh)
Choi YJ, Lee S, Kim Y, Park S, Kim HJ.
europepmc   +1 more source

Analytical Solution for Lamb Wave Generation and Sensing in Thin Plates Through Adhesively Bonded Flexoelectric Transducers

Suraj Kumar Rout, S. Kapuria
openalex   +1 more source

High‐Temperature Oxidation of the CrFeNi Medium‐Entropy Alloy

Advanced Engineering Materials, EarlyView.
The oxidation behavior of equiatomic CrFeNi MEA is a key issue that determines this material's suitability for high‐temperature application. The understanding of long‐term behavior is even more crucial than short‐term corrosion effects. The alloy is exposed to synthetic air at 1000, 1050, and 1100 °C for 24, 100, and 1000 h and systematically compared ...
Anna Maria Manzoni, Wencke Mohring, Mike Schneider, Guillaume Laplanche, Sebastian Peter Hagen, Christiane Stephan‐Scherb   +5 more
wiley   +1 more source

Effect of artificial sweat, pigmentation and adhesives for fixing facial prostheses on physical and optical properties of two facial silicones. [PDF]

Biomater Investig Dent
Martins G, Dos Santos DM, Dos Santos BLM, de Caxias FP, Goiato MC.   +4 more
europepmc   +1 more source

Dealing with multiaxial non-proportional fatigue with varying mean stress: Invariant and critical plane approaches for component-like structural adhesive joints

Evangelista Fernandes, Pedro Henrique, Nagel, Christof, Carrillo Beber, Vinicius, Unav   +3 more
openalex   +1 more source