Results 51 to 60 of about 1,203,016 (292)

Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies

Advanced Engineering Materials, EarlyView.
Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo, Daniela Winsley Valereto Friozi, Vinícius de Oliveira, Marcia Cristina Branciforti   +3 more
wiley   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres

Advanced Engineering Materials, EarlyView.
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann, René Gustus, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +3 more
wiley   +1 more source

Sequestration of hexavalent chromium and paracetamol from water using deoiled hemp stem-twigs and roots and activated carbon

Environmental Challenges
In the present study, deoiled hemp stem-twigs and roots and activated carbon were used to remove chromium and paracetamol. The hemp-based materials were characterized, and the surface area of the activated carbon samples increased more than 55-fold ...
B.R. Mphuthi, P.M. Thabede, I.P. Ledwaba, M. Mlambo, S. Mpelane, N.D. Shooto   +5 more
doaj   +1 more source

Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere

Advanced Engineering Materials, EarlyView.
A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz, Maik Szafarska, René Gustus, Kai Möhwald, Hans Jürgen Maier   +4 more
wiley   +1 more source

Assessment of Miscanthus × giganteus derived biochar as copper and zinc adsorbent:study of the effect of pyrolysis temperature, pH and hydrogen peroxide modification [PDF]

, 2017
In this work, experimental and modelling investigations were conducted on biochars pyrolyzed at 350 °C and 600 °C, to determine the effect of pyrolysis temperature, hydrogen peroxide activation and pH on copper and zinc removal, in comparison with ...
Bissessur, Ajay, Cibati, Alessio, Foereid, Bente, Hapca, Simona M.   +3 more
core   +6 more sources

Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio

Advanced Engineering Materials, EarlyView.
This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov, Matheus Roberto Bellé, Anton Yehorov, Julia Richter, Olena Volkova   +4 more
wiley   +1 more source

Highly Thermally Conductive and Structurally Ultra-Stable Graphitic Films with Seamless Heterointerfaces for Extreme Thermal Management

Nano-Micro Letters, 2023
Highlights Presenting the first investigation into the structurally bubbling-failure mechanism of graphitic film during cyclic liquid nitrogen shocks.
Peijuan Zhang, Yuanyuan Hao, Hang Shi, Jiahao Lu, Yingjun Liu, Xin Ming, Ya Wang, Wenzhang Fang, Yuxing Xia, Yance Chen, Peng Li, Ziqiu Wang, Qingyun Su, Weidong Lv, Ji Zhou, Ying Zhang, Haiwen Lai, Weiwei Gao, Zhen Xu, Chao Gao   +19 more
doaj   +1 more source

Novel Tailoring of Ternary ZnS‐MXene‐TiO2 Nanocomposite Heterojunction and Its Tunable Electrochemical Properties With Enhanced Photocatalytic Degradation

Advanced Engineering Materials, EarlyView.
ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir, Dohyun Kim, Minho Song, Jae Doc Na, Young Jun Joo, Kwang Youn Cho, Karna Wijaya, Won‐Chun Oh   +7 more
wiley   +1 more source

Electrochemical Conversion of Toluene Derivatives to Aromatic Nitriles Using Water (H2O) and Ammonia (NH3)

ChemElectroChem
Aromatic nitriles are extensively produced chemicals with a wide variety of applications. The high demand of these compounds justifies the search for sustainable synthesis alternatives using renewable energy. Here, an electrochemical oxidation of toluene
Sander Spittaels, Jef Vanhoof, Dirk E. De Vos   +2 more
doaj   +1 more source