Results 11 to 20 of about 11,618 (311)
Aggregate interlock in lightweight concrete continuous deep beams [PDF]
Engineering Structures, 2011 There are very few, if any, available experimental investigations on aggregate interlock capacity along diagonal cracks in lightweight concrete deep beams. As a result, the shear design provisions including the modification factor of ACI 318-08 and EC 2 for lightweight concrete continuous deep beams are generally developed and validated using normal ...
Yang, Keun-Hyeok, Ashour, Ashraf
openaire +2 more sources
Performance of Ore Sand as Aggregate for Interlocking Blocks
Applied Sciences, 2023 The search for alternatives that can replace conventional materials extracted from nature is crucial for environmental sustainability. This is especially the case for construction and geotechnical engineering, as this sector is a major consumer of the planet’s natural resources.
Rodrigo Beck Saldanha +3 more
openaire +2 more sources
Shear design of HSC beams with combination of links and horizontal web steel [PDF]
, 2012 The existing recommendations in Eurocode 2 and the British Code of Practice for the shear design of beams are derived from research conducted essentially on normal-strength concrete (NSC) with cube strengths up to 50 MPa, and it was found that the shear ...
Al-Hussaini, Abbas +2 more
core +2 more sources
Application of fibre composite grids as reinforcement of foamed PC and GP concrete [PDF]
MATEC Web of Conferences, 2019 Cellular concretes cannot be reinforced as easily as traditional ones. Generally porous materials do not ensure sufficient bond of reinforcement; additionally, due to limited amount of aggregate, interlock between aggregate particles and reinforcement ...
Krzywoń Rafał +3 more
doaj +1 more source
The Baltic Journal of Road and Bridge Engineering, 2020 Aggregate interlock is the dominant load transfer mechanism in non-dowelled Jointed Plain Concrete Pavements, as the innovative short concrete slabs.
Mauricio Pradena +2 more
doaj +1 more source
Aggregate effect on the concrete cone capacity of an undercut anchor under quasi-static tensile load [PDF]
, 2018 In the last decades, fastening systems have become an essential part of the construction industry. Post-installed mechanical anchors are frequently used in concrete members to connect them with other load bearing structural members, or to attach ...
Boumakis, Ioannis +4 more
core +3 more sources
Influence of aggregate fracture on shear transfer through cracks in reinforced concrete [PDF]
, 2011 Design methods for shear in reinforced concrete structures typically rely upon shear transfer through cracks, which depends upon the crack opening and sliding displacements and the roughness of the crack surfaces.
Sagaseta, J, Vollum, RL
core +2 more sources
Load transfer-crack width relation of non-dowelled jointed plain concrete short slabs
The Baltic Journal of Road and Bridge Engineering, 2018 Non-dowelled short slabs are a cost-effective innovation of jointed plain concrete pavements. The development of this innovation has been concentrated in their structural performance.
Mauricio Pradena, Lambert Houben
doaj +1 more source
Experimental evaluation of load transfer efficiency of non-dowelled concrete pavements
Građevinar, 2022 Generally, joint performance in concrete pavements is evaluated in laboratory by applying dynamic loads that require large scale experimental setups. In order to propose a simplified laboratory test, a comprehensive literary review of the fundamentals of
Mauricio Pradena +2 more
doaj +1 more source
Shear Behavior of High Strength Self-Compacting Concrete with Lower Transverse Reinforcement Index
Journal of Applied Science and Engineering, 2022 Self-Compacting Concrete (SCC) generally has lesser coarse aggregate contents and also the maximum size of aggregates is limited as compared to Normal Vibrating Concrete (NVC) for the same class of strength. This results in reduced aggregate interlock in
Aijaz Ahmad Zende +2 more
doaj +1 more source