Results 251 to 260 of about 4,623,161 (291)
Some of the next articles are maybe not open access.
Inspection of CFRP components by ultrasonic imaging with air-coupling
Insight - Non-Destructive Testing and Condition Monitoring, 2004This paper reports the investigations of air coupled ultrasonic imaging techniques which are part of the German research project MaTech. Project partners are Airbus, Bremen, Ingenieurburo Dr. Hillger, Braunschweig, and intelligeNDT, Erlangen, with DLR, Braunschweig, as subcontractor.
Hillger, Wolfgang +2 more
openaire +3 more sources
AIR-COUPLED LONG WAVES IN THE OCEAN
Journal of Meteorology, 1960Abstract An IGY tsunami recorder at Texas Tower No. 4 off New York has detected ocean waves of periods from 4 to 10 min which have amplitudes up to 100 times greater than atmospheric pressure oscillations which occurred simultaneously. The latter are shown to be pressure perturbations generated by internal surface waves on a frontal discontinuity aloft.
William L. Donn, William T. McGuinness
openaire +1 more source
Air-coupled ultrasonic scanner for Braille
2001 IEEE Ultrasonics Symposium. Proceedings. An International Symposium (Cat. No.01CH37263), 2002This work presents an air-coupled ultrasonic scanner to digitize Braille texts. Braille is a system of touch reading for the blind which employs embossed dots. Air-coupled focused piezoelectric transducers, for this particular application were designed, produced and characterized. A conventional 2D scan system for NDE applications was used.
T.E. Gomez +2 more
openaire +1 more source
Air-Coupled Ultrasonic Applications of Ferroelectrets
Ferroelectrics, 2008Improvement of ferroelectret transducers for air-coupled ultrasonic applications was demonstrated on the base of optimization of the ferroelectret electromechanical properties and adjustment of the ferroelectret transducers to the ultrasonic system. Controlled inflation of the polypropylene ferroelectret films results in an increase of the coupling ...
Viktor Bovtun +6 more
openaire +1 more source
A Study of Air-Coupled Ultrasonic Flowmeter
Volume 5: Fusion Engineering; Student Paper Competition; Design Basis and Beyond Design Basis Events; Simple and Combined Cycles, 2012A new non-contact flow metering system is developed using air-coupled ultrasonic technique. The principle of the present system is based on the time-of-flight (TOF) ultrasonic flowmeter. The TOF ultrasonic flowmeter has two transducers, a transmitter and a receiver, which are strapped on the outside wall of a pipe.
Keisuke Tsukada +2 more
openaire +1 more source
Air – coupled ultrasonic transducers with collimators
Ultrasound, 2009Air – coupled planar ultrasonic transducers with collimators can be effectively used for a wide range of distances when air-coupled focussed transducers are being exploited only at the fixed distance. On the other hand use of attached collimators on the planar transducers allows choosing a relatively wide range of spatial resolutions, what is very ...
A. Vladišauskas +2 more
openaire +1 more source
Novel Ultrasonic air Coupled Transducers
1999Airborne ultrasound is currently used for a variety of applications, including distance ranging, level monitoring, broken ply detection and for the limited non-destructive testing of low Z materials (such as green-state ceramics, rubber and carbon fiber composite).
Billson, D. +3 more
openaire +2 more sources
Air-Coupled Nondestructive Evaluation Dissected
Journal of Nondestructive Evaluation, 2018This work develops a two-dimensional theoretical model to simulate the behavior of a fully non-contact air-coupled nondestructive evaluation system for a thin isotropic plate. The model is divided into transmission, guided wave propagation and reception phase.
Mohammad Said Harb, Fuh-Gwo Yuan
openaire +1 more source
Wideband air – coupled ultrasonic transducers
Ultrasound, 2004Wideband air – coupled ultrasonic transducers.
R. Kažys +2 more
openaire +1 more source
Characterization of mineral paper by air-coupled ultrasonic spectroscopy
Ultrasonics, 2012A novel technology in the paper industry makes possible to produce paper by using a mineral powder and a polymer instead of cellulose fibers. This new product is called mineral paper, it presents some potential environmental advantages compared with conventional paper, while it exhibit a similar appearance and properties. The purpose of this work is to
T E, Gómez Álvarez-Arenas, D A, Soto
openaire +2 more sources

