Results 71 to 80 of about 4,479,393 (285)

Lone‐Pair‐Induced Lattice Distortion in Lead‐Free Hybrid Perovskites for High‐Performance Nanogenerators

open access: yesAdvanced Functional Materials, EarlyView.
A lead‐free tin‐based hybrid perovskite is designed in which stereochemically active lone‐pair electrons on tin distort the crystal lattice and break its symmetry. Blended into a flexible polymer, the material converts pressure into electricity at milliwatt‐scale power density and continues working far below freezing, powering a commercial wristwatch ...
Majid Haji Bagheri   +12 more
wiley   +1 more source

Neuromorphic Devices for Extreme Environments: State‐Variable Reliability and Stabilization Strategies

open access: yesAdvanced Functional Materials, EarlyView.
Neuromorphic devices for extreme environments are interpreted through the physical states that store and process information. Radiation, temperature extremes, and vacuum can perturb vacancies, filaments, trapped charges, polarization, interfaces, and readout signals.
Taehyun Park   +7 more
wiley   +1 more source

A miniature coupled bistable vibration energy harvester [PDF]

open access: yes, 2014
This paper reports the design and test of a miniature coupled bistable vibration energy harvester. Operation of a bistable structure largely depends on vibration amplitude rather than frequency, which makes it very promising for wideband vibration energy
Zhu, Dibin   +5 more
core   +1 more source

A Miniaturized Autonomous Thermomagnetic Generator

open access: yesAdvanced Functional Materials, EarlyView.
Micro, autonomous and high power thermomagnetic generator operating between a heat dissipator and a processor. ABSTRACT Thermomagnetic generators (TMG) are promising devices for converting low‐grade waste heat into electricity. Self‐actuation using permanent magnets is the key to autonomy.
Morgan Almanza   +11 more
wiley   +1 more source

Ferroelectret transducers for air-coupled ultrasonic testing of fiber-reinforced polymers

open access: yes, 2013
Ferroelectrets are promising materials for air-coupled ultrasonic transducers. A transducer made of polarized cellular polypropylene, including its electronic interface, was developed and compared with conventional air-coupled probes.
M. Kreutzbruck   +13 more
core   +1 more source

Air-coupled UT transducers

open access: yes, 2022
S.95-105Based upon piezoelectric composite materials, air borne ultrasonic probes with frequencies above 100 kHz were developed. These probes are characterized by a bandwidth larger than 50 % as well as a signal-to noise ratio higher than 100 dB.
Gebhardt, W.
core   +1 more source

Exceptional Electro‐Optic Coefficient Unlocked via Polarization Swaying in KNbO3 Thin Films

open access: yesAdvanced Functional Materials, EarlyView.
We present the largest reported electro‐optic response in any material to date, guided by a new design principle that exploits ultralow coercive field polarization swaying enabled by low‐symmetry ferroelectric phases in monoclinic KNbO3 thin films for energy‐efficient classical and quantum photonic integrated circuits. ABSTRACT The electro‐optic effect
Sankalpa Hazra   +11 more
wiley   +1 more source

The application of air-coupled ultrasonic systems and signal processing to the interrogation of concrete [PDF]

open access: yes
This thesis describes the application of ultrasound to the interrogation of concrete for the retrieval of quantitative information. In particular the use of air-coupled ultrasound is applied for the first time with recent improvement in ultrasonic ...
Berriman, James Robert Stockwell
core  

Additive manufacture of impedance matching layers for air-coupled ultrasonic transducers [PDF]

open access: yes
A key problem in designing an efficient ultrasonic transducer for operating in a low acoustic impedance medium such as air is the large impedance mismatch between the active piezoceramic material and the load medium. While acoustic matching layers can be
Ramadas, Sivaram Nishal   +5 more
core   +1 more source

Surface micromachined capacitive ultrasonic transducers [PDF]

open access: yes, 1998
The current state of a novel technology, surface microfabricated ultrasonic transducers, is reported. Experiments demonstrating both air and water transmission are presented.
Khuri-Yakub, B. T.   +9 more
core   +2 more sources

Home - About - Disclaimer - Privacy