Results 131 to 140 of about 135,830 (309)
Advanced Engineering Materials, EarlyView.This study applies machine learning regression to predict chromium layer thickness in decorative trivalent chromium electroplating, using 441 experiments from laboratory‐scale (1L) and pilot‐scale (14L) setups. Tree‐based models, particularly CatBoost, outperformed linear regression by capturing nonlinear parameter interactions (R2$R^2$ up to 0.77 ...
Christoph Baumer +4 more
wiley +1 more source
, 2010 Environmental flows are central to equitable distribution of and access to water and services provided by aquatic ecosystems. They refer to the quality, quantity, and timing of water flows required maintaining the
World Bank
core +1 more source
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Computational and experimental models of induction flows in spark-ignition engines [PDF]
, 1988 The objective of this thesis is to combine computational flow modelling, flow visualization and point measurements of mean flow and turbulence properties to obtain a better, more detailed, understandýing of the effects of alternative throttling ...
Sanatian, R.
core
Active Corrosion Protection of Sintered AA7075 Aluminum Alloy via Mn Powder Addition
Advanced Engineering Materials, EarlyView.AA7075 containing Mn‐rich particles is fabricated via spark plasma sintering using AA7075 and Mn powders. Corrosion resistance is evaluated through dip‐and‐dry tests using 0.1 M NaCl (pH 6.0), and mass loss decreases with increasing Mn addition. Mn‐rich particles function as a source of Mn ions, and formation of Mn‐accumulation films on Cu‐containing ...
Ko Ebina, Masashi Nishimoto, Izumi Muto
wiley +1 more source
Biomass Native Structure Into Functional Carbon‐Based Catalysts for Fenton‐Like Reactions
Advanced Functional Materials, EarlyView.This study indicates that eight biomasses with 2D flaky and 1D acicular structures influence surface O types, morphology, defects, N doping, sp2 C, and Co nanoparticles loading in three series of carbon, N‐doped carbon, and cobalt/graphitic carbon. This work identifies how these structural factors impact catalytic pathways, enhancing selective electron
Wenjie Tian +7 more
wiley +1 more source
Engineering Applications of Computational Fluid MechanicsThe complex interfacial interactions between air and water in pipe drainage process largely affect the pipe flow development and hence becomes a hot topic in urban sewerage engineering.
Yuejin Cai +4 more
doaj +1 more source
Multiphase flow can be defined as the simultaneous flow of a stream of two or more phases. Solids-in-water flow is a multiphase flows where solids and liquid are both present. Due to the density differences of the two phases, the results for such flow is
Muhamedsalih, Yousif
core
Advanced Functional Materials, EarlyView.Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Modeling Mist to Annular Flow Development in the Discharge of a Compressor
, 2012 A model has been created to describe the development of flow leaving a compressor as it transitions from mist to annular flow. Flow parameters such as the drop size, drop speed, drop concentration, film thickness, and film velocity change as a function ...
Wujek, Scott S., Hrnjak, Predrag S.
core