Results 31 to 40 of about 3,641,286 (288)
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Chiral modes near exceptional points in symmetry broken H1 photonic crystal cavities
Physical Review Research, 2021 The H1 photonic crystal cavity supports two degenerate dipole modes of orthogonal linear polarization which could give rise to circularly polarized fields when driven with a π/2 phase difference.
C. F. Fong +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This article investigates the dependence of the properties on the manufacturing orientation in the form of the inclination angle to the build plate of LPBF‐fabricated NiTi rods with a diameter of 150–220 µm. Metallographic, chemical, thermal, and mechanical characterization show behavior under identical manufacturing conditions that ranges from ...
Sandra Herzig +2 more
wiley +1 more source
Turbulent boundary layer development over an air cavity
FlowThe turbulent boundary layer (TBL) development over an air cavity is experimentally studied using planar particle image velocimetry. The present flow, representative of those typically encountered in ship air lubrication, resembles the geometrical ...
Abhirath Anand +3 more
doaj +1 more source
Experiments and CFD modeling of high-velocity two-phase flows in a large chute aerator facility
Engineering Applications of Computational Fluid Mechanics, 2019 Mathematical formulations of two-phase flows at an aerator remain a challenging issue for spillway design. Due to their complexities in terms of water–air interactions subjected to high flow velocities, experiments play an essential role in evaluations ...
James Yang, Penghua Teng, Hongwei Zhang
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
Fluids, 2021 Air-ventilated cavities formed under or around the hulls of marine vehicles can reduce water drag. Hull configurations with partial air ventilation where air cavities reattach to body surfaces are of special practical interest, since the required air ...
Konstantin I. Matveev +1 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Despite benefits to storage stability and handleability of aluminum scrap, octadecyl phosphonic acid (ODPA) SAMs reduce the tensile strength of wires produced using friction‐induced recycling. Etching and methyl diphosphonic acid (MDPA) coatings, however, have little effect.
Timothy D. Goller +3 more
wiley +1 more source
Energy Reports, 2022 A coupled computational fluid dynamics and discrete particle method numerical model is developed to provide a systematic analysis of buoyant convective particle-laden air flow and heat losses from a solar cavity receiver with free-falling particles.
Sahan Trushad Wickramasooriya Kuruneru +3 more
doaj +1 more source