Results 201 to 210 of about 890,762 (338)

AIRCRAFT NUCLEAR PROPULSION: FLUORIDE FUEL PREPARATION FACILITY

, 1954
Ellen. Joseph, F.L. Daley, Blake Hannaford, E.L. Youngblood   +3 more
openalex   +2 more sources

Development of n‐type ZnAlInO Semiconductor Materials for Thermoelectric Generators in Aerospace Applications

ChemistryOpen, EarlyView.
Herein, the synthesis and production of n‐type ZnAlInO semiconductor materials is achieved utilizing sol–gel and cold pressing methods for fabrication in aerospace thermoelectric generators applications. The Seebeck coefficient and power factor values increase with the addition of template samples, reaching a maximum of −162.63 μV K−1 and 0.44 mW mK−2,
Enes Kilinc, Fatih Uysal, Mucahit Abdullah Sari, Huseyin Kurt, Erdal Celik   +4 more
wiley   +1 more source

Study on static and dynamic performance of aircraft maintenance hangar under multiple load combinations. [PDF]

PLoS One
Liu X, Chen Z, Zhu F, Chen H.
europepmc   +1 more source

Trip Report - Metallic Hydrides (American Chemical Society, 127th Meeting, Cincinnati, April 6-7, 1955; Wright Air Development Center, April 8, 1955; Conference on Metallic Hydrides as Moderators in Nuclear Aircraft Engines)

, 1955
Paul Gilbert
openalex   +2 more sources

Closure to “Discussions of ‘The Aircraft Diesel Engine’” (1930, Trans. ASME, 52(1), pp. 43–48) [PDF]

, 1930
Leigh M. Griffith, Edward T. Vincent
openalex   +1 more source

Aircraft to Aircraft Connectivity Analysis

, 2018
It is very common to feel the need to be connected, especially in cases where we are idle, such as in airplanes. Aircraft connectivity has already been implemented by using direct air-to-ground communication and satellite communication. However, since the current solutions are not satisfying, more ways to provide connectivity to aircraft are being ...
openaire   +1 more source

Modeling short fiber reinforced polymer matrix composite materials using material designer

Polymer Composites, EarlyView.
Modeling Short Fiber Composites: A Material Designer Approach. Abstract In the present era, the importance of simulations pertaining to production is increasing in terms of cost, human resources, and time. As the majority of existing studies on polymer matrix composites are experimental, the development of a modeling approach for these materials will ...
Busra Eyri, Okan Gul, N. Gamze Karsli, Taner Yilmaz   +3 more
wiley   +1 more source

Automatic dependent surveillance-broadcast (ADS-B) anomalous messages and attack type detection: deep learning-based architecture. [PDF]

PeerJ Comput Sci
Ahmed W, Masood A, Manzoor J, Akleylek S.   +3 more
europepmc   +1 more source

Notch sensitivity in aircraft structural and engine alloys [PDF]

, 1956
H. R. Voorhees, James W. Freeman
openalex  

Lay‐up defects inspection for automated fiber placement with structural light scanning and deep learning

Polymer Composites, EarlyView.
Lay‐up defects inspection for automated fiber placement with structural light scanning and deep learning. Abstract Automated fiber placement (AFP) is an advanced manufacturing technology for large‐scale carbon fiber reinforced plastics (CFRP) composite parts.
Chongrui Tang, Deyong Sun, Jianchao Zou, Yifeng Xiong, Guoxin Fang, Weizhao Zhang   +5 more
wiley   +1 more source