Results 181 to 190 of about 10,816 (218)
Some of the next articles are maybe not open access.
Surface Topography in Machining of AISI D2 Hardened Steel
Applied Mechanics and Materials, 2013Surface topography plays an important part in understanding the nature of machined surfaces. This study is focused on surface topography of AISI D2 hardened steel (58-62 HRC) under dry milling process. Roughness, surface morphology and defects analysis were investigated.
N.A.H. Jasni, Mohd Amri Lajis
openaire +1 more source
Influence of Cutting Edge Radius in Micromachining AISI D2
Applied Mechanics and Materials, 2013Chip formation is a dynamic process that is often non linear in nature. A chip may not form when the depth of cut is less than a minimum chip thickness. This paper presents an investigation of cutting edge radius effect on micromachining AISI D2 tool steel via simulation.
J.B. Saedon +4 more
openaire +1 more source
Prediction of Boride Thickness on Tool Steels AISI D2 and AISI H13 Using Boriding Kinetics
Advanced Materials Research, 2014Cold and hot work tool steels AISI D2 and AISI H13, respectively, were borided using a packed boriding process. Boriding temperature range of 1123 1223 K was performed with different boriding time up to 6 hr, afterwards, near-surface properties of the borided tool steels AISI D2 and H13 were characterized.
Yossapong Boonplook, Patiphan Juijerm
openaire +1 more source
Surface Integrity in Hot Machining of AISI D2 Hardened Steel
Advanced Materials Research, 2012This study presents experimental results of machined surface integrity of die material (AISI D2 hardened steel) when hot machining (induction heating) assisted end milling using coated carbide is applied. The aim of this work was to study the influence of induction heating temperature, cutting speed, and feed on the effects induced by hard milling on ...
Mohd Amri Lajis +2 more
openaire +1 more source
Investigation of the AISI D2 Shaft Punch Damage
2022Ben Saada, Fatma +3 more
openaire +3 more sources
AISI D2 ve AISI D3 soğuk iş takım çeliklerinin frezede işlenebilirliğinin incelenmesi
2014Bu çalışmada, 20 HRC sertliğindeki AISI D2 ve 28 HRC sertliğindeki AISI D3 soğuk iş takım çeliğinin kuru kesme şartlarında zıt yönlü ve kesikli yüzey frezeleme işlemiyle talaşlı imalattaki işlenebilirliliğinin incelenmesi amacıyla düşey BSD işleme merkezinde deneysel araştırma yürütülmüştür.
openaire +1 more source
Study of Mechanical Properties of Friction Welded AISI D2 and AISI 304 Steels
2023Sinta Restuasih +5 more
openaire +1 more source
Nitriding of Steel AISI D2 After Deep Cryogenic Treatment
Metal Science and Heat Treatment, 2023F. D. Ramos +4 more
openaire +1 more source