Results 91 to 100 of about 1,120,503 (214)
Discrimination of D2 steel roughness after hard milling [PDF]
This article discusses the discrimination of machined surfaces following the milling of 62 HRC hardened AISI D2 steel, a material used in the industrial sector due to its considerable harnesses and resistance to wear.
Souid Abdallah +2 more
doaj +1 more source
Deep cryogenic treatment in AISI D2 tool steel punches to enhance tool life
Fabiano Dornelles Ramos +2 more
doaj +1 more source
In addition to the bulk properties of a workpiece material, characteristics of the tribofilms formed as a result of workpiece material mass transfer to the friction surface play a significant role in friction control.
Junfeng Yuan +5 more
doaj +1 more source
Additive manufacturing through Laser Powder Bed Fusion (L-PBF) offers significant advantages for tooling applications. However, its implementation in high-load tribological conditions is limited by process-induced defects.
Sunil Kumar +3 more
doaj +1 more source
Regression Modeling of EDM Process for AISI D2 Tool Steel with RSM
In this paper, Response Surface Method (RSM) is utilized to carry out an investigation of the impact of input parameters: electrode type (E.T.) [Gr, Cu and CuW], pulse duration of current (Ip), pulse duration on time (Ton), and pulse duration off time ...
Shakir M. Mousa
doaj +2 more sources
EFFECT OF PARAMETER CONDITION ON SURFACE ROUGHNESS FOR MACHINING AISI D2 HARDENED TOOL STEEL [PDF]
Hardened steel such as AISI D2 is often used in mould and die industry. Some of the application required to have good surface quality profile and sophisticated free-form shape simultaneously. In current industry practice, manual polishing and grinding is
Arfauz, M. +5 more
core +2 more sources
This study investigates multi-objective optimization of end-milling parameters for AISI D2 cold-worked tool steel using GC1130-coated carbide inserts under wet machining, focusing on cutting speed and feed rate per tooth values beyond manufacturer ...
Luis W. Hernández +3 more
doaj +1 more source
Determining Ms temperature on a AISI D2 cold work tool steel using magnetic Barkhausen noise.
The use of Magnetic Barkhausen Noise (MBN) as a experimental method for measuring the martensite start (Ms) temperature was explored, using as model system a cold-work tool steel (AISI D2) austenitized at a very high temperature (1473 K), so as to ...
Padovese, Linilson Rodrigues +3 more
core +1 more source
The present paper deals with studying the effect of electrical discharge machining (EDM) and shot blast peening parameters on work piece fatigue lives using copper and graphite electrodes.
Ahmed Al-Khazraji +2 more
doaj +2 more sources

