Results 61 to 70 of about 8,383 (269)
Characterization and wear performance of boride phases over tool steel substrates [PDF]
, 2016 This research work was conducted to characterize boride phases, obtained from the powder-pack process, on AISI H13 and D2 steel substrates, and investigate their tribological behavior.
Bernal Ponce, J.L. +6 more
core +1 more source
Advanced Functional Materials, Volume 35, Issue 46, November 12, 2025.The pre‐internalization phase of endocytosis remains poorly characterized at single‐cell levels. Single‐cell pre‐internalization mechanics are investigated using advanced robotic techniques. Cancer cells exhibit biphasic adhesion – rapid initial binding followed by reinforcement – while fibroblasts show gradual engagement.
Houari Bettahar +6 more
wiley +1 more source
Investigation of Cutting Performance of Nano/Layered Hard Coatings in Face Milling of AISI D2 Steel
Düzce Üniversitesi Bilim ve Teknoloji Dergisi, 2023 In the die-molding industry, milling steels in a hardened condition is common. Tool wear and cutting-forces occurring during this process must be considered for better surface quality.
Bilal Kurşuncu
doaj +1 more source
The effects of material combination and surface roughness in lubricated silicon nitride/steel rolling contact fatigue [PDF]
, 2003 Four kinds of commercially finished 12.7 min HIPed silicon nitride bearing balls with surface roughness values R-a ranging from 0.002 to 0.016 mum were tested using a four-ball rolling configuration.
Ahmed, R, Hadfield, M, Kang, J
core +1 more source
Journal of Applied Polymer Science, Volume 142, Issue 27, July 15, 2025.ABSTRACT Investigating the mechanical and wear properties of widely used PETG (polyethylene terephthalate glycol) filaments is important to understanding the material's performance, reliability, and suitability in different application areas. This study performed tensile and wear tests on PETG samples produced with a 3D printer using four infill ...
Enes Aslan +2 more
wiley +1 more source
Effects of chromium powder mixed in electrical discharge machining of AISI D2 hardened steels [PDF]
, 2015 Nowadays, electrical discharge machining (EDM) is the non-conventional method that has been used extensively in machining hard material that is commonly used in mold and die industry but the limitations of EDM will cause lower productivity and poor ...
Idris, Muhammad Ridzuan
core
An Atomic‐Scale View at γ’‐Fe4N as Hydrogen Barrier Material
Advanced Materials Interfaces, Volume 12, Issue 13, July 14, 2025.This study demonstrates the efficacy of γ’‐Fe4N nitride layers, formed via gas nitriding, as hydrogen permeation barriers. Advanced characterization, hydrogen permeation analysis, and DFT calculations reveal a 20 fold reduction in hydrogen diffusion at room temperature.
Aleksander Albrecht +11 more
wiley +1 more source
Materials Research Express, 2023 The presence of retained austenite in the hardening process of tool steel often causes the lower hardness compared to the hardness requirements and poor dimensional stability in the tool steel.
Myrna Ariati Mochtar +2 more
doaj +1 more source
Effects of cryogenic treatment on AISI D2 steel
, 1994 Bibliography: p. 189-201.
openaire +2 more sources
Lubricants, 2016 In addition to the bulk properties of a workpiece material, characteristics of the tribofilms formed as a result of workpiece material mass transfer to the friction surface play a significant role in friction control.
Junfeng Yuan +5 more
doaj +1 more source