Results 81 to 90 of about 112,677 (274)
All dielectric metamaterial loaded tunable plasmonic waveguide
AIP Advances, 2017 In this article, a 2D plasmonic waveguide loaded with all dielectric anisotropic metamaterial, consisting of alternative layers of Si-SiO2, has been theoretically proposed and numerically analyzed. Main characteristics of waveguide i.e.
Abid Anjum Sifat +2 more
doaj +1 more source
All-Dielectric Metasurface Lenses for Achromatic Imaging Applications
Nanoscale Research Letters, 2022 Metasurface can use artificial microstructures to manipulate electromagnetic waves more accurately and flexibly. All-dielectric metalens have a wide range of materials and low cost so it has a wide application prospect.
Menghan Li +5 more
doaj +1 more source
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
, 2019 Bound states in the continuum (BICs) are ubiquitous in many areas of physics, attracting especial interest for their ability to confine waves with infinite lifetimes.
Abujetas, Diego R. +6 more
core +3 more sources
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Active Tuning of All-Dielectric Metasurfaces
ACS Nano, 2015 All-dielectric metasurfaces provide a powerful platform for highly efficient flat optical devices, owing to their strong electric and magnetic dipolar response accompanied by negligible losses at near-infrared frequencies. Here we experimentally demonstrate dynamic tuning of electric and magnetic resonances in all-dielectric silicon nanodisk ...
Sautter, Jurgen +6 more
openaire +3 more sources
Advanced Engineering Materials, EarlyView.Micro‐Raman spectroscopy is applied to characterize corrosion products in a recycled‐based MgO–316L steel composite anode after molten salt electrolysis. A depth‐dependent Fe–O/Fe–Al–O layer sequence of magnetite, hercynite, and an Al‐doped magnetite transition zone is identified.
Felix Drechsler +9 more
wiley +1 more source
All-dielectric photonic-assisted wireless receiver
Optics Express, 2008 High Power Microwave (HPM) weapons and other sources of intense microwave power pose a growing threat to modern RF receivers. To address this problem, all-dielectric photonic-assisted receivers have been proposed and demonstrated. Here, we describe a new configuration of this type with 15 dB better sensitivity over prior designs.
Ali, Ayazi +4 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain +7 more
wiley +1 more source