Results 101 to 110 of about 1,396,595 (289)
HARD SPOT IN LIGHT DIE-CASTING ALLOYS ITS CAUSES AND REMEDIES
, 1956 Ichiji Obinata
openalex +2 more sources
Assessing the Ecological Value: Monetizing Process Innovations in Tailored Forming
Advanced Engineering Materials, EarlyView.This article introduces a method for evaluating the sustainability of innovations, even with limited data. The method is illustrated through an analysis of the “Tailored Forming” technology, which explores the impact of sustainability on economic value added.
Jonas Schneider +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Temporal power modulation increases weld depth in high‐power laser beam welding of dissimilar round bars by nearly 20% compared to same average continuously welded welding power. The mechanism of action also applies to sheet welding and depends on the inertia of keyhole depth for the modulated laser beam power.
Jan Grajczak +7 more
wiley +1 more source
Anomaly Detection Method for Hybrid Workpieces Using Dynamic Time Warping
Advanced Engineering Materials, EarlyView.Monitoring of hybrid workpieces: when machining hybrid workpieces, unavoidable axial deviations of the material transition zone cause temporal shifts in the process force signals. A new anomaly detection method based on dynamic time warping is proposed to detect material defects.
Berend Denkena +3 more
wiley +1 more source
Optimization of homogenization for a low alloyed AlMgSi alloy
Materials Characterization, 2013 Abstract The homogenization practice for EN AW 6060 was investigated. It takes an 8-hour soak at 580 °C to level out the Mg and Si distribution in the matrix and to transform the monoclinic β-Al5FeSi plates into relatively small α-AlFeSi particles. The solute Si and Mg are largely retained in solution during subsequent cooling at > 500 °C h− 1. Mg2Si
openaire +3 more sources
LXIII. On the electromotive force of alloys [PDF]
, 1883 John Trowbridge, E. K. Stevens
openalex +1 more source
From Damage to Functionality: Remanufacturing of Thrust Roller Bearings by Tailored Forming
Advanced Engineering Materials, EarlyView.Herein, the wear and fatigue behavior of repaired bearing raceways with a new powder alloy is investigated using a FE8 test‐rig and an oscillating tribometer. The tests are compared with industrial manufactured bearings to evaluate the repair quality. The repair can extend the service life of the repaired bearing to that of a new bearing and improves ...
Felix Saure +3 more
wiley +1 more source
Simulation of Inhomogeneous Refractive Index Fields Induced by Hot Tailored Forming Components
Advanced Engineering Materials, EarlyView.This article presents a simulation model for simulating inhomogeneous refractive index fields (IRIF) in hot‐forged components, accounting for thermal influences and complex geometries. Through this simulation, a priori knowledge about the propagation of the IRIF can be obtained, allowing for the positioning of the component or an optical measurement ...
Pascal Kern +3 more
wiley +1 more source
Properties and microstructures for dual alloy combinations of three superalloys with alloy 901 [PDF]
Dual alloy combinations have potential for use in aircraft engine components such as turbine disks where a wide range of stress and temperature regimes exists during operation.
Harf, F. H.
core +1 more source