Results 11 to 20 of about 402,756 (235)
Solidification behaviour of magnesium alloys [PDF]
, 2013 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.Magnesium alloys have been extensively used for structural and functional applications due to their low densities.
Jiang, Bo
core +7 more sources
Solidification and processing of aluminium based immiscible alloys [PDF]
, 2009 Copyright @ 2009 TMSThe Al-Sn and Al-Pb based immiscible alloys have significant potential for bearing applications. However, the mixing and understanding of solidification process for immiscible alloys have been long standing challenges for their ...
Patel, JB +4 more
core +6 more sources
The Stability of NiTi shape memory alloys and actuator applications
, 1999 Recent research and development in the area of shape memory alloys (SMA) continues to yield novel and unique results. Of the alloys that display the effect NiTi alloys have found the most commercial interest resulting in a number of niche applications ...
Morgan, Neil
core +7 more sources
Pressure effects on the hot-salt stress-corrosion cracking of titanium alloys [PDF]
, 1994 Benefiting from good specific mechanical properties, exceptional oxidation resistance, and high temperature capability, Titanium Alloys are used in Gas Turbine Engines, especially in the early stages of the compressor.
Chevrot, Thierry
core +7 more sources
Hot deformation behavior, microstructure evolution and slip system of Mg-2Zn-0.5Mn-0.2Ca alloy
Journal of Materials Research and Technology, 2022 The hot deformation behavior of as-cast Mg-2Zn-0.5Mn-0.2Ca alloys was investigated by hot compression tests conducted at 250–400 °C with strain rates of 0.001–1 s−1.
Deqing Ma +6 more
doaj +1 more source
Journal of Materials Research and Technology, 2023 In this study, the microstructure, mechanical properties and corrosion behavior of as-extruded Mg–2Zn–0.5Mn–xCa (x=0, 0.2, 0.4) alloys were investigated.
Deqing Ma +4 more
doaj +1 more source
Construction of flexible and wearable 3D TiO2 NTs@Ti mesh for physiological detection based on sweat
JCIS Open, 2021 The biosensors with flexibility and breathability turn out to be a vital means of non-intrusive detection of multi-components biochemical markers in human sweat. For this end, three-dimensional (3D) structure TiO2 nanotube arrays were in-situ established
Jianwei Yu +8 more
doaj +1 more source
Results in Materials, 2023 The flow behavior of as-extruded Mg–3Sn-1.5Mn (wt.%) alloy was systematically researched via isothermal compression tests. The compressive temperatures (T) were from 250 °C to 400 °C, the strain rates were from 0.001 s−1 to 1s−1 and the true strain ...
Yunduo Feng +7 more
doaj +1 more source
Journal of Materials Research and Technology, 2023 The flow stress behavior of Mg–3Sn–1Mn alloy during thermal compression deformation was systematically studied. The thermal compression simulation experiment was carried out at different deformation temperatures and different strain rates in the range of
Xiaowei Li +7 more
doaj +1 more source
Journal of Materials Research and Technology, 2022 The microstructure, mechanical properties, and damping performance of Mg–4Li–3Al–0.3Mn alloy were systematically investigated in this research. The results show that the microstructure of Mg–4Li–3Al–0.3Mn alloy is significantly refined after extrusion ...
Gang Zhou +9 more
doaj +1 more source