Results 1 to 10 of about 746,731 (226)
Frontiers in Materials, 2021 Aluminide coating is prepared on K438 Ni-based superalloy by pack cementation. The hot corrosion test of as-received and pre-oxidation aluminide coating in Na2SO4 salt are carried out at 1050°C.
Qing Li +6 more
doaj +2 more sources
Materials Research Express, 2020 The hot corrosion behaviors of the aluminide coatings with different treatments on the surface of Ni-based alloy at high temperature were investigated.
Jubo Peng +9 more
doaj +2 more sources
Type-I hot corrosion behavior of Cr-modified slurry aluminide coating superalloy Rene 80 [PDF]
Scientific ReportsIn this study, the structure and type-I hot corrosion behavior of chromium-modified slurry aluminide coatings obtained by chromizing/Cr-plating before the slurry aluminizing have been discussed.
K. Shirvani +3 more
doaj +2 more sources
Crystals, 2021 The oxidation performance of a single-phase Pt-modified aluminide coating was assessed in oxidation test at 980 °C in comparison with the single crystal superalloy. The results suggested that the Pt-modified aluminide coating exhibited superior oxidation
Yanyan Li +4 more
doaj +2 more sources
Microstructure and hot corrosion behavior of slurry silicon-aluminide coating modified by chromizing and chromium plating on superalloy Rene-80 [PDF]
Scientific ReportsIn this article, the microstructural characteristics of silicon-aluminide coatings with and without Cr applied on Rene-80 nickel-based superalloy substrates are presented and analyzed.
S V Miraboutalebi +3 more
doaj +2 more sources
SEM/TEM Investigation of Aluminide Coating Co-Doped with Pt and Hf Deposited on Inconel 625. [PDF]
Materials (Basel), 2018 The effect of simultaneous introduction of Hf and Pt into aluminide coating deposited on Inconel 625 alloy was investigated using scanning and transmission electron microscopy (SEM/TEM) methods.
Morgiel J +3 more
europepmc +2 more sources
Microstructural investigation of low-activity and high-activity aluminide coatings fabricated by vapor phase aluminizing on IN792 superalloy [PDF]
Scientific ReportsTo improve the oxidation and hot corrosion resistance of components, parts for gas turbine engines made of nickel-based superalloys are often coated with aluminide coatings. Various methods apply these coatings on superalloys.
Ali Azari Beni, Saeed Rastegari
doaj +2 more sources
Effect of ZR Content on Oxide-Scale Spallation of Aluminide Coating
Iranian Journal of Materials Science and Engineering, 2019 In the present study, Zirconium modified aluminide coating on the nickel-base superalloy IN-738LC was first created by high activity high temperature aluminizing based on the out-of-pack cementation method.
R. Latifi, S. Rastegari, S. H. Razavi
doaj +2 more sources
Research Progress of Palladium - Modified Aluminide Coating on Nickel - Based Superalloy [PDF]
Cailiao Baohu, 2021 The palladium - modified aluminide coating could improve the high - temperature oxidation resistance and heat corrosion resistance of the aluminide coating. The addition of Pd made the NiAl phase have higher high - temperature stability and could inhibit
XIA Si - yao, WU Yong, ZHANG Bo - wen, HUANG Tian - zong
doaj +1 more source
Temperature-Dependent Effect of Microstructure of Aluminide Coating Prepared by CVD [PDF]
Cailiao Baohu, 2023 Owing to the advantages of non-line-of-sight deposition，the aluminide coating preparation technology is widely used on key hot-end components of gas turbines， and can prepare oxidation-resistant and corrosion-resistant aluminide coatings on the outer ...
QI Haoxiong, WU Yong, LIU Meijun, MENG Guohui, SUN Qingyun, CHEN Tongzhou, DUAN Haitao, YANG Guanjun
doaj +1 more source