Results 251 to 260 of about 102,666 (312)

Unraveling the particle size characteristics-flame retardancy relationship in ATH/polyolefin composites: a focus on interfacial properties and thermal decomposition. [PDF]

RSC Adv
Wang H, Liu X, Han X, Yuan L.
europepmc   +1 more source

Influence of reinforcement on the fracture surface characteristics of multistage solutionized and precipitation-hardened ternary Al-Mg-Si hybrid composites. [PDF]

Sci Rep
Shettar M, Kumar N, Hariharan G, Shankar G, Hegde A.   +4 more
europepmc   +1 more source

Mechanical Stability and Binder Interaction in MOF Composites: An Integrated Experimental and DFT Study. [PDF]

ACS Omega
Silva FH, Paiva MAM, Nangoi IM, Lima MET, da Silva TVF, Flores LS, Menezes RB, Corrêa CC, Leitão AA.   +8 more
europepmc   +1 more source

The Role of FeCoNiCrAl Particle Pretreatment in Interface Bonding and Properties of Cu/FeCoNiCrAl Composites. [PDF]

Materials (Basel)
Zhu R, Zong S, Li X, Feng J, Gong W.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Aluminium carbide formation in interpenetrating graphite/aluminium composites

Materials Science and Engineering: A, 2007
We have produced interpenetrating graphite/aluminium composites by gas pressure infiltration of aluminium alloys with varying silicon content into porous graphite preforms. Infiltration experiments at 750 °C have shown that a silicon content of up to 18 wt.% can reduce the formation of aluminium carbide but cannot completely deter it.
T. Etter, P. Schulz, M. Weber, J. Metz, M. Wimmler, J.F. Löffler, P.J. Uggowitzer   +6 more
openaire   +3 more sources

THE COMPOSITION OF ALUMINIUM STEARATE

Canadian Journal of Research, 1948
The composition of aluminium stearate as normally prepared approximates that of the distearate. Extraction over extended periods, using ethyl alcohol, acetone, and methyl ethyl ketone as extractants, reduced the proportion of stearic acid to that of a monobasic soap.
W, GALLAY, I E, PUDDINGTON
openaire   +2 more sources

Hot Drilling of Aluminium Matrix Composite

Materials Science Forum, 2011
The aim of this paper is to investigate the behaviour in terms of drilling forces and roughness of Metal Matrix Composites (MMC) in hot drilling machining. In particular, Al2009/(SiC)w, Al6061/(SiC)w, and Al6061(Al2O3)p metal matrix composites were used, and the adopted temperature were in the range 20°C-160°C.
Donnini R, SANTO, LOREDANA, TAGLIAFERRI, VINCENZO   +2 more
openaire   +2 more sources