Results 51 to 60 of about 536 (148)

Simulating pneumatic brake systems with AMESIM

, 2005
AMESim is successfully used for the design of braking systems and components by a large number of manufacturers and OEMs. The motivation and the main goals for the research project between the Institute of Product Development and the Knorr-Bremse SfS are to show a tool for the project planning of the systems and to present guidelines for systems, which
openaire   +1 more source

Study and Experimental Verification on Anti-Disturbance Control Strategy for Electro-Mechanical Servo Systems

Actuators
With technological advances and industrial upgrading, electro-mechanical actuators (EMAs) have gradually replaced traditional hydraulic actuation systems.
Shicheng Zheng, Deyi Wang, Jingkun Wei, Yunjie Yang, Jihong Zhu   +4 more
doaj   +1 more source

ABS Pneumatic Modulator Control for the Truck Hill Start in the Automatic Mode of the Power Unit

Механика машин, механизмов и материалов, 2018
The paper shows the principle scheme of truck mechatronic control system with hill-hold capability, it also describes control strategy of ABS pneumatic modulator as hill-start system in automatic mode of power unit.
Van Nghia Le
doaj  

Research of Shifting Quality of Dual Hydro-mechanical Transmission

Jixie chuandong, 2018
The hydro-mechanical transmission（ HMT） is obtained by connecting hydraulic transmission and mechanical transmission in parallel. It has the advantages of high torque of hydraulic transmission and high mechanical transmission efficiency.
Xia Kuoyuan, Sun Baoqun, Chang Jia’nan, Xie Hai   +3 more
doaj  

Analysis of influencing factors on vibration characteristics of electro-hydraulic vibration cutting system. [PDF]

Sci Rep, 2023
Xie M, Meng Q, Zhang W, Wang H, Guo J, Liu Y, Yan W, Li B.   +7 more
europepmc   +1 more source

Design of tractor virtual test system based on high-level architecture technology. [PDF]

PLoS One, 2023
Yan X, Shang C, Zhang J, Xu L.
europepmc   +1 more source

长距离上运带式输送机张紧特性的研究和分析

Jixie chuandong, 2013
Aiming at modern coal mine product boost and requirement of the long range belt conveyor, through the quantitative analysis of steeply inclined belt conveyor, the engineering mechanical knowledge is applied to analyze the tension force of the belt ...
董安, 潘宏侠, 龚明
doaj  

Cross-Coupled Sliding Mode Synchronous Control for a Double Lifting Point Hydraulic Hoist. [PDF]

Sensors (Basel), 2023
Sun C, Dong X, Li J.
europepmc   +1 more source

Vibration response difference of caving mechanism under coal rock impact based on mechanical-hydraulic coupling. [PDF]

Sci Rep, 2023
Zhu Y, Zeng Q, Wan L, Yang Y, Li Z.
europepmc   +1 more source

湿式离合器在AT换挡时的压力估计与仿真分析

Jixie chuandong, 2013
In order to control of shifting process of the AT in the process of clutch-to-clutch shift,the wet clutch pressure estimation observer is proposed in the concept of ISS and the designed observer is tested on an AMESim power train simulation model,which ...
盛德号
doaj