Results 111 to 120 of about 3,016,682 (331)
Analysis of Second-Order HPF and LPF Circuit Simulations as Digital Signal Amplification Filters
The writing of this paper focuses on describing and relating simple modeling and analysis to the simulation of High-PassFilter (HPF) and Lowpass filter (LPF) designs using Op-Amp, which previously used an analog system and then converted into a digital ...
Pascal Siregar +4 more
doaj +1 more source
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source
Binder‐free laser powder bed fusion of 8YSZ with a femtosecond laser is used to map process windows linking scan strategy, heat accumulation, and grain growth. Time‐resolved thermography and simulations reveal thermal regimes that enable continuous, vitrified, and fine‐grained 8YSZ surface layers without absorptive additives and demonstrate ...
Markus Kühn +5 more
wiley +1 more source
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
PUF/ENB microcapsules were synthesized based on a sequential factorial design and incorporated into an epoxy matrix. Their anticorrosive action, associated with the self‐healing mechanism, demonstrated that the addition of microcapsules to the coating improved anticorrosive performance compared to pure epoxy coatings, particularly when the encapsulate ...
Vandicleya Alves Moreira +6 more
wiley +1 more source
Systems and methods for analog finite impulse response filters
Systems and methods for analog finite impulse response (FIR) filters are provided. In certain embodiments, a receiver includes a cascade of a mixer, an analog FIR filter, and an analog-to-digital converter (ADC).
Nauta, Bram ; id_orcid +3 more
core
Analogue Filter IP Cores for Design Reuse
This paper addresses important considerations concerning the design of analogue filters, to ensure their suitability for use in a system on chip environment as intellectual property filter cores.
Al-Hashimi, B. M., Wilcock, R
core +1 more source
Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe +9 more
wiley +1 more source
Digital Auto-Tuning System for Analog Filters
In this paper, a new self-tuning digital technique is reported for analog filters over VHF (very high frequency) applications, based on phase detector. By using a 0.35 mum mixed signal CMOS process, changes in frequency response of a 3rd-order low pass ...
Medrano Marqués, N. +9 more
core +1 more source
Edible Cuttlefish Ink: Complex Chemistry, Structure, and Electrical Response
An integrated approach of chemistry‐structure‐electrical properties is used to assess the potential of edible cuttlefish ink as a bio‐based conductive ink for printable electronics. Chromatography and Neutron Activation Analysis reveal a fascinating molecular and elemental diversity.
Camille Bour‐Cardinal +5 more
wiley +1 more source

