Results 251 to 260 of about 165,556 (311)

Cr and Nd co-doped cobalt oxide for stable proton exchange membrane water electrolysis. [PDF]

Nat Commun
Gao T, Li F, Hung SF, Yang H, Sun Y, Peng KS, Sha Q, Mao Q, Tao H, Chen P, Liu B.   +10 more
europepmc   +1 more source

Upcycling agro-waste into sustainable bioenergy: using carbonized cabbage core wastes bio-anodes and novel bacterial insights in MFCs for sugarcane wastewater treatment. [PDF]

Microb Cell Fact
Abotaleb A, Ramadan M, Amin DH, Elsayed AF, Barakat NAM, Shaltout A, El Shahawy A.   +6 more
europepmc   +1 more source

Polarity-Dependent EDM-Type Degradation in Rolling Bearings Under Low-Speed Unipolar Excitation. [PDF]

Materials (Basel)
Li Z, Cai R, Zhang T, Nie X.
europepmc   +1 more source

Electro-Oxidation and Electro-Fenton Degradation of PFASs Using a Grid-Shaped Ti₄O₇ Magnéli-Phase Anode: Effect of Concentration and Evidence of Defluorination. [PDF]

Materials (Basel)
Daghfous S, Makhoul E, Petit E, Lesage G, Bechelany M, Bellakhal N, Cretin M.   +6 more
europepmc   +1 more source

Entropy-Modulated Oxide-Metal Catalyst Architectures for Direct Ammonia Protonic Ceramic Fuel Cells. [PDF]

Nanomicro Lett
Kim D, Park DJ, Jeong I, Oh S, Kim H, Lee M, Lee SW, Lee K, Chung D, Roh KM, Bae J, Shin TH, Lee KT.   +12 more
europepmc   +1 more source

Designing High-Performance Dual-Ion Batteries at High-Voltage: Challenges, Strategies, and Prospects. [PDF]

Nanomicro Lett
Han C, Xu YS, Hu Z, Cao AM, Chen G.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Anodization and Anodic Oxides

2018
Anodizing is a low-temperature, low-cost electrochemical process allowing for the growth, on the surface of valve metals and valve metal alloys, of anodic oxides of tunable composition and properties. This article is an overview on theoretical aspects concerning the general aspects of the kinetics of growth of barrier and porous anodic oxides and some ...
Di Franco F., Zaffora A., Santamaria M., Di Quarto F.   +3 more
openaire   +1 more source

Anodic Polarization of Anodized Aluminum

Corrosion, 1969
Potentiostatic anodic polarization of anodized coatings on aluminum was sensitive to both coating thickness and degree of seal. The polarization behavior of anodized coatings parallels their performance in atmospheric service. Thus, anodic polarization could be used as a test for the atmospheric corrosion resistance of anodized coatings. The advantages
openaire   +1 more source

Anodic oxidation of benzoquinone using diamond anode

Environmental Science and Pollution Research, 2014
The anodic degradation of 1,4-benzoquinone (BQ), one of the most toxic xenobiotic, was investigated by electrochemical oxidation at boron-doped diamond anode. The electrolyses have been performed in a single-compartment flow cell in galvanostatic conditions. The influence of applied current (0.5-2 A), BQ concentration (1-2 g dm(-3)), temperature (20-45
openaire   +3 more sources

Anodization of molybdenum. I. Galvanostatic anodization

Journal of Applied Electrochemistry, 1987
Molybdenum was anodized at different current densities (10−4–10−2 A cm−2) in various aqueous solutions. Potential-time curves obtained in strong acid solutions are similar to those usually reported for the valve metals, and the anodization kinetics were found to obey the familiar exponential law $$i = A \exp BH$$ and also to obey the empirical ...
A. G. Gad-Allah, H. A. Abd El-Rahman
openaire   +1 more source