Results 31 to 40 of about 329,958 (322)
Enhanced physical properties of the anodic TiO2 nanotubes via proper anodization time
Journal of Theoretical and Applied Physics, 2018 Vertically aligned titanium dioxide (TiO2) nanotubes were synthesized by electrochemical anodic oxidation in an electrolyte solution containing 0.45 wt% ammonium fluoride (NH4F) and 2 vol% deionized water at constant potential (70 V) for various ...
Zahra Jedi-soltanabadi +2 more
doaj +1 more source
AN INVESTIGATION OF THE POROUS SILICON OPTICAL-ABSORPTION POWER-LAW NEAR THE BAND-EDGE [PDF]
, 2002 A theoretical investigation of the absorption coefficient of p-type doped porous silicon near the band edge is presented. We assume that the absorption coefficient is constructed by taking an average over a distribution (in terms of band gap) of ...
CHOY, TC, DERLET, PM, STONEHAM, AM
core +1 more source
Nanopatterning of steel by one-step anodization for anti-adhesion of bacteria
Scientific Reports, 2017 Surface nanopatterning of metals has been an effective technique for improved performance and functionalization. However, it is of great challenge to fabricate nanostructure on carbon steels despite their extensive use and urgent needs to maintain the ...
Shiqiang Chen, Yuan Li, Y. F. Cheng
semanticscholar +1 more source
Chemical analysis of a single basic cell of porous anodic aluminium oxide templates [PDF]
, 2010 We prepared anodic aluminium oxide (AAO) templates with “honeycomb” geometry, i.e. hexagonally ordered circular pores. The structures were extensively studied and characterized by EPMA coupled with FEG-SEM and FEG-TEM coupled with EDX at meso and ...
Arurault, Laurent +2 more
core +2 more sources
KKU Engineering Journal, 2016 Anodization of Ti sheet in the ethylene glycol electrolyte containing 0.38wt% NH4F with the addition of 1.79wt% H2O at room temperature was studied. Applied potential of 10-60 V and anodizing time of 1-3 h were conducted by single-step and three-step of ...
Mallika Thabuot, Chaiyaput Kruehong
doaj +1 more source
Aligned metal oxide nanotube arrays: key-aspects of anodic TiO2 nanotube formation and properties
, 2016 Over the past ten years, self-aligned TiO2 nanotubes have attracted tremendous scientific and technological interest due to their anticipated impact on energy conversion, environment remediation and biocompatibility.
Nguyen, Nhat Truong +3 more
core +1 more source
Plasma, 2023 In this study, 6061 Al alloy was galvanostatically anodized under the Plasma Electrolytic Oxidation (PEO) condition. A factorial design of 22 was carried out using two variables (anodization time and presence of silver in the electrolyte) on two levels ...
Francisco Trivinho-Strixino +5 more
doaj +1 more source
Role of microstructure in porous silicon gas sensors for NO$_2$
, 2003 Electrical conductivity of porous silicon fabricated form heavily doped p-type silicon is very sensitive to NO$_2$, even at concentrations below 100 ppb. However, sensitivity strongly depends on the porous microstructure.
Bettotti, Paolo +6 more
core +1 more source
Thin Film Superconducting Devices [PDF]
, 1973 Techniques have been developed with which it is possible to fabricate superconducting thin film structures (“bridges”) which show Josephson-like phenomena, with a wide variety of electrical and superconducting parameters.
Mercereau, J. E., Notarys, H. A.
core +1 more source
Effects of various applied voltages on physical properties of TiO2 nanotubes by anodization method
, 2017 Three steps anodization process is used to synthesize highly ordered and uniform multilayered titanium oxide (TiO2) nanotubes and effect of different anodization voltages are studied on their physical properties such as structural, morphological and ...
T. Hoseinzadeh +4 more
semanticscholar +1 more source