Results 121 to 130 of about 5,598 (255)

A study of hardcoat anodizing on PM Al-Mg composite

, 2008
This research is being conducted to investigate an effect occurring on anodizing process on powder metallurgy Aluminium-Magnesium (PM Al-Mg) composite.
Mohd Nasuha Ab. Halim
core  

Sliding properties of anodized aluminium alloy tested in water and hydraulic oil. [PDF]

Sci Rep
Trajkovski A, Bartolj J, Novak N, Pustavrh J, Kalin M, Majdič F.   +5 more
europepmc   +1 more source

High Light Utilization and Color Rendering in Vacuum‐Deposited Semitransparent Perovskite Solar Cells

Advanced Materials, EarlyView.
In this work, low bandgap (≈1.55 eV) semitransparent perovskite solar cells (ST‐PSCs) having thin (thickness < ≈100 nm) perovskite layers and transparent conductive oxide‐based rear electrodes are fabricated using vacuum‐deposition methods. Two different ST‐PSCs demonstrated a high light utilization efficiency value of 4.2 (PCE: 9.26% and AVT: 45.3 ...
Abhyuday Paliwal, Manuel Romero, Lennart van den Hengel, Nathan Rodkey, Kassio P. S. Zanoni, Gabriel Lozano, Cristina Roldán‐Carmona, Michele Sessolo, Hernán Míguez, Henk J. Bolink   +9 more
wiley   +1 more source

Dehydration-Driven Changes in Solid Polymer Electrolytes: Implications for Titanium Anodizing Efficiency. [PDF]

Materials (Basel)
Valencia-Cadena A, García-Blanco MB, Santamaría P, Roa JJ.   +3 more
europepmc   +1 more source

POM‐Based Water Splitting Catalyst Under Acid Conditions Driven by Its Assembly on Carbon Nanotubes

Advanced Materials, EarlyView.
A newly‐engineered POM‐based electrocatalyst incorporating non‐innocent counter cations exhibits fast kinetics for either the OER or HER under strongly acidic conditions (1 m H2SO4), depending on whether it is assembled on carbon nanotubes (1@CNT) or physically mixed with them (1/CNT). In water‐splitting tests using a two‐electrode setup, these systems
Eugenia P. Quirós‐Díez, Melanie Guillén‐Soler, Carlos Herreros‐Lucas, Alejandro López‐Moreno, José Manuel Vila‐Fungueiriño, Antonio Luis Llamas‐Saiz, Karol Strutyński, Manuel Melle‐Franco, María del Carmen Giménez‐López   +8 more
wiley   +1 more source

Nanostructure-Dependent Signal Intensity in Through-Hole Porous Alumina Membranes for Mass Spectrometry Imaging. [PDF]

Rapid Commun Mass Spectrom
Kotani M, Yanagishita T.
europepmc   +1 more source

Polyimide‐Linked Hexaazatriphenylene‐Based Porous Organic Polymer with Multiple Redox‐Active Sites as a High‐Capacity Organic Cathode for Lithium‐Ion Batteries

Advanced Materials, EarlyView.
A high‐capacity polyimide‐linked porous organic polymer (HAT‐PTO) incorporating numerous redox‐active centers is synthesized via a hydrothermal reaction, delivering a high theoretical capacity of 484 mAh g−1. In situ hybridization with carboxyl‐functionalized multiwalled carbon nanotubes enhances conductivity and stability, achieving 397 mAh g−1 at C ...
Arindam Mal, Jonathan Caroni, Asia Patriarchi, Olivera Luzanin, Rafael Ramos, Jan Bitenc, Manuel Melle‐Franco, Manuel Souto   +7 more
wiley   +1 more source

Micro-Arc Oxidation of Ti-45Nb Alloy: Surface Characteristics and Corrosion Behavior for Potential Biomedical Application. [PDF]

ACS Omega
Barboza ECS, Rocha MA, Rocha DF, Oliveira AS, Reis MMS, Griza S.   +5 more
europepmc   +1 more source

Atomistic Mechanisms Triggered by Joule Heating Effects in Metallic Cu‐Bi Nanowires for Spintronics

Advanced Materials, EarlyView.
Bi doped metallic Cu nanowires are promising for spintronics thanks to the stabilization of a giant spin Hall effect. However, heat resulting from current injection forces Bi to leave solution, forcing segregation into monoatomic decorations which evolve into coherent crystalline aggregates.
Alejandra Guedeja‐Marrón, Juan Ignacio Beltrán, Matilde Saura‐Múzquiz, Paolo Perna, M. Carmen Muñoz, Lucas Pérez, Maria Varela   +6 more
wiley   +1 more source

Formation Mechanism and Dielectric Properties of Ultra-High-Voltage Anodic Al Foils Investigated by ReaxFF-MD and DFT. [PDF]

Materials (Basel)
Chu X, Ji Y, Yao C, Wu J, Song X, Liu X, Li H, Wang X, Yang W, Wu J, Dong C.   +10 more
europepmc   +1 more source