Results 61 to 70 of about 7,139 (201)

Numerical Thermal‐Hydraulic Evaluation of an Integrated Direct‐Indirect Oil Cooling System for an Electric Motor Under Steady‐State Overload Conditions

Advanced Theory and Simulations, Volume 9, Issue 6, June 2026.
This study evaluates an integrated direct‐indirect oil cooling system for electric motor thermal management under steady‐state overload conditions. The results show that the combined cooling architecture improves heat removal from the winding, stator, and housing while balancing pressure drop penalties.
Tai Duc Le, Seong‐Guk Hwang, You‐Ma Bang, Jung‐Su Park, Loc‐Xuan Tong, Taek‐Kyu Lim, Moo‐Yeon Lee   +6 more
wiley   +1 more source

Numerical Analysis of Influence of Thickness of Liquid Film on Bottom Cover to Heat Transfer in Thermosyphon in Conditions Emergency Modes of Work the Rechargeable Batteries of Aircrafts

EPJ Web of Conferences, 2016
Numerical analysis of thermal conditions of a two-phase closed thermosyphon using the software package ANSYS FLUENT has been carried out. Dynamics of change of thickness of the liquid film depending on time impact of heat load are obtained.
Krasnoshlykov A.S.
doaj   +1 more source

Modeling of hydrogen electrochemical processes with ANSYS-Fluent

, 2023
El present projecte té com a objectiu comprendre la simulació de PEM (membranes d'intercanvi protònic) tant en cel·les de combustible com en processos d'electròlisi utilitzant el software Ansys Fluent. Per començar, s'ha donat prioritat a la simulació de cel·les de combustible PEMFC a causa de l'abundància de literatura disponible per a consultar.
openaire   +1 more source

Simulation Of Coffee Stain Effects Using ANSYS Fluent

Journal of Physics: Conference Series, 2019
AbstractThe following project takes an investigative look in the commonly observed coffee stain effect in fluid dynamics that explains the arrangement and alignment of particles and droplets when subjected to an evaporative flux. The primary objective of the paper deals with the methodology and results obtained by the simulation of the effect in ANSYS ...
openaire   +1 more source

Tar Removal From Biomass‐Derived Syngas via Scrubbing: A Review on Process and Modeling

ChemBioEng Reviews, Volume 13, Issue 3, June 2026.
This review article surveys contaminant formation and removal in biomass‐derived syngas, with a focus on tar scrubbing. It synthesizes evidence from benchmark plants and compares scrubbing configurations and solvents to assess performance and operating limits.
Simon Brinkmann, Thomas Grützner, Bernhard C. Seyfang   +2 more
wiley   +1 more source

An Integrated Lumped Parameter Model and Computational Fluid Dynamics Framework for Predicting Hemodynamic Parameters in Pulmonary Vein Stenosis

Comprehensive Physiology, Volume 16, Issue 3, June 2026.
This work presents a novel computational simulation framework for the study of pulmonary venous hemodynamics that integrates a closed‐loop lumped parameter model (LPM) of the cardiovascular system with a computational fluid dynamics (CFD) model of the pulmonary veins and left atrium. Coupling of the LPM and CFD models was accomplished through surrogate
Alessia Di Nardo, David A. Romero, Rachel D. Vanderlaan, Cristina H. Amon   +3 more
wiley   +1 more source

Numerical analysis of gas flow dynamics of propane pyrolysis

Advanced Engineering Research, 2018
Introduction. Homogeneous pyrolysis of propane is studied in a flow reactor with constant external heating. A numerical analysis of the results of simulating the gas flow in the reactor with account of chemical processes is required for a comprehensive ...
I. M. Gubaydullin, L. F. Nurislamova
doaj   +1 more source

Nonsilting transport characteristics of coal slurry in a deep underground fluidization conveying pipeline under the action of a guide vane swirler

Deep Underground Science and Engineering, Volume 5, Issue 2, Page 539-555, June 2026.
Aiming at the scientific frontiers of in situ fluidized mining of deep resources, a deep coal fluidized pipeline lifting system based on hydraulic conveying has been proposed. To solve the issue of particle sedimentation of large particles in horizontal connection sections, a solution involving the installation of guide vane‐type swirlers in the ...
Jiusheng Bao, Shaodi Zhao, Yan Yin, Zhongbin Wang, Shuai Liu, Shirong Ge   +5 more
wiley   +1 more source

Optimized Mesh Zoning for Dam Bottom Outlet CFD Simulations Using Richardson Extrapolation and Grid Convergence Analysis

Engineering Reports, Volume 8, Issue 6, June 2026.
A Richardson‐extrapolation–based mesh zoning framework is developed to optimize CFD simulation accuracy and computational efficiency in dam bottom outlet flows. Using six mesh scenarios and multi‐parameter convergence analysis (pressure, velocity, TKE), the method identifies an optimal fine‐resolution zone around the gate and progressively coarser ...
Mohammad Masoud Vaseti, Ali Akbar Akhtari, Reza Tarinejad   +2 more
wiley   +1 more source

Research On the Load‐Bearing Characteristics of Porous Air Bearings Applied to Ultra‐Precision Spindles

Engineering Reports, Volume 8, Issue 6, June 2026.
This study analyzes the load‐bearing characteristics of large‐scale porous graphite air bearings for ultra‐precision spindles using CFD simulations. The results elucidate the effects of key design parameters on static performance, offering a theoretical foundation for optimizing wafer thinning machine components.
Peng Zhang, Yuhang Jia, Hao Liu
wiley   +1 more source