Results 101 to 110 of about 475 (164)
A dual‐modulus silicone release film creates distributed stress concentrations at high‐/low‐modulus boundaries, triggering multi‐site crack initiation and rapid interfacial detachment. The architecture lowers the peak separation force by 97.6%, shortens detachment time, and enables stable continuous projection stereolithography at 720 mm h−1, offering ...
Xiaogang Li +3 more
wiley +1 more source
Research/technology development demonstrated physicochemical/mechanical properties of transformational integration of hydroxyapatite (HAp) scaffolds and HAp scaffolds coated with a unique breakthrough biocompatible ultrananocrystalline diamond (UNCD) coating produced by microwave plasma chemical vapor deposition (MPCVD) process.
Angelica M. Castillo‐Paz +6 more
wiley +1 more source
Conformal Coating and Transfer of 2D Nanomaterials via Dynamic Interface Engineering
This review discusses conformal coating and transfer of two‐dimensional (2D) nanomaterials with a focus on dynamic interface engineering. By actively regulating nanosheet transport and interfacial contact during film formation, recent dynamic coating strategies overcome the limitations of conventional passive approaches and enable geometry‐adaptive ...
Seungyeon Kim +4 more
wiley +1 more source
This study develops a self‐cleaning solar evaporator based on MXene‐coated aramid nanofiber aerogels for efficient desalination under high‐salinity conditions. The cylindrical evaporator combines strong photothermal conversion, capillary water transport, and self‐rotation triggered by salt accumulation.
Mandeep Singh +5 more
wiley +1 more source
Xenon flash lamp annealing modulates oxygen‐vacancy states in 1‐nm‐thick ALD In2O3 transistors within a single 139 µs pulse. The photon‐induced defect engineering shifts the threshold voltage, improves bias‐stress stability, and narrows device‐to‐device variation across 64 devices. Combining pristine and treated transistors yields NMOS inverters with a
Sung Jin Park +5 more
wiley +1 more source
Control of Bacterial Attachment on Macroporous PDMS/Paraffin SLIPS With Varying Lubricant Viscosity
Slippery liquid‐infused porous surfaces (SLIPS) prepared from macroporous PDMS, infused with medical‐grade paraffins, were systematically investigated regarding the correlation of viscosity, surface corrugation, bulk porosity, and bacterial resistance. Substrate porosity was found to dominate lubricant stabilization and the antifouling activity.
Regina Kopecz +3 more
wiley +1 more source
Enhanced Xylene Sensing Performance of Fe‐Doped NiO Nanosheet Arrays via In Situ Growth
Xylene is a hazardous volatile organic compound (VOC) widely present in industrial environments, and achieving sensitive and stable detection of xylene remains a significant challenge for gas sensors. Here, a one‐step hydrothermal route was employed to in situ grow p‐type Fe‐doped NiO nanosheet arrays on ceramic tubes for xylene detection.
Yinglin Wang +12 more
wiley +1 more source
The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz +5 more
wiley +1 more source
High Throughput Aerosol Jet Printing to Operationalize High Aspect Ratio Patterning
High‐throughput aerosol jet printing poses distinct limiting mechanisms to the printing process. These include rapidly changing ink chemistries, atomization instabilities, and liquid‐phase spreading. The combination of in‐line heating, process monitoring, and traditional optimization procedures enables rapid printing of high‐aspect‐ratio structures ...
Bella I. Guyll +4 more
wiley +1 more source

