Results 31 to 40 of about 36,041 (254)
Changes in anterior chamber depth following vitrectomy
Chinese Medical Journal, 2013 Background Anterior segment morphometry is crucial for ophthalmologists to understand the visual outcomes of cataract surgery, keratorefractive surgery, as well as some other anterior segment disorders. Previous reports in literature have shown that anterior chamber depth (ACD) may shift slightly after vitrectomy.
Yang, Li +3 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
CORRELATION OF ANTERIOR CHAMBER DEPTH WITH PERIPAPILLARY NERVE FIBER LAYER THICKNESS
Pakistan Armed Forces Medical Journal, 2018 Objective: To determine correlation of anterior chamber depth with peripapillary nerve fiber layer thickness. Study Design: Descriptive cross sectional study.
Bilal Hassan +5 more
doaj
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Studies on the depth of the anterior chamber
Indian Journal of Ophthalmology, 1967 Shukla B, Srivastava S
doaj +2 more sources
SAGE Open Medicine, 2022 Objectives: We aimed at investigating the iridocorneal angle, anterior segment structural differences, and their relationship in pediatric anisohyperopic amblyopic eyes. Methods: This study was designed as an observational case-control study.
Müjdat Karabulut +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Micro‐Raman spectroscopy is applied to characterize corrosion products in a recycled‐based MgO–316L steel composite anode after molten salt electrolysis. A depth‐dependent Fe–O/Fe–Al–O layer sequence of magnetite, hercynite, and an Al‐doped magnetite transition zone is identified.
Felix Drechsler +9 more
wiley +1 more source
Clinical Ophthalmology, 2021 Waleed M Alghamdi, Saif H Alrasheed, Vishakh Nair, Muhammed S Alluwimi Department of Optometry, College of Applied Medical Sciences, Qassim University, Buraydah, Saudi ArabiaCorrespondence: Saif H AlrasheedQassim Unversity, P.O. Box 1162, Buraydah, Saudi
Alghamdi WM +3 more
doaj