Results 31 to 40 of about 24,580 (311)
Data in BriefWire arc additive manufacturing is considered to allow a reduced material consumption for structural steel components by efficiently distributing the material only where necessary.
Vlad-Alexandru Silvestru
doaj +1 more source
Effects of Thermal Cycling on Wire and Arc Additive Manufacturing of Al-5356 Components
Metals, 2020 Wire and arc additive manufacturing (WAAM) provides a promising alternative to conventional machining for the production of large structures with complex geometry, as well as individualized low quantity components, using cost-efficient production ...
Markus Köhler +2 more
doaj +1 more source
AI OpenWelding thick metal plates using Multi-Layer-Multi-Pass (MLMP) techniques demands precise control over the weld seam profile as it evolves during the cooling process. In MLMP welding, typically executed with Gas Metal Arc Welding (GMAW) and shielding gas
He Wang +4 more
doaj +1 more source
Flow loss and structure of circular arc blades with different leading edges
Advances in Mechanical Engineering, 2018 Due to much lower cost of development and production, circular arc blades are often applied to axial flow fans. However, compared with NACA 65 profile, circular arc blades have higher losses, which are caused by the formation of separation bubbles or ...
Tao Bian +4 more
doaj +1 more source
Bistable Mechanisms 3D Printing for Mechanically Programmable Vibration Control
Advanced Engineering Materials, EarlyView.This work introduces a 3D‐printed bistable mechanism integrated into tuned mass dampers (TMDs) for mechanically adaptive passive vibration suppression. Through optimized geometry, the bistable design provides adaptable vibration reduction across a broad range of scenarios, achieving effective vibration mitigation without complex controls or external ...
Ali Zolfagharian +4 more
wiley +1 more source
Optical tomography of the aurora and EISCAT [PDF]
Annales Geophysicae, 1998 Tomographic reconstruction of the three-dimensional auroral arc emission is used to obtain vertical and horizontal distributions of the optical auroral emission.
H. U. Frey +5 more
doaj +1 more source
Effect of electrode geometry on maximum arc pressure in gas tungsten arc welding.
QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1985 Effects of an electrode geometry on the maximum arc pressure at a base metal were investigated in GTA welding.Results obtained are as follows;(1) The pressure increases with a decrease in a vertex angle of an electrode. But at the vertex angle of 45° the pressure has a peak value and then the pressure decreases with the decrease in the angle less than ...
Kazuo Hiraoka +2 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.This study investigates laser shock peening for enhancing fatigue performance of riveted aerospace aluminum joints. A comparative approach with cold expansion combines fatigue testing and synchrotron X‐ray methods. Integrating mechanical testing with residual stress and strain characterization provides insights into how different treatments affect the ...
Ogün Baris Tapar +6 more
wiley +1 more source
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Materials & Design, 2019 This paper documents an investigation into the microstructures and melt pool geometry features of Ti6Al4V + (0, 1, 2, 5, 10, wt%) B alloys processed by selective laser melting (SLM).
Yining He +3 more
doaj +1 more source