Results 81 to 90 of about 35,746 (264)
Calcium silicates synthesised from industrial residues with the ability for CO2 sequestration [PDF]
, 2014 This work explored several synthesis routes to obtain calcium silicates from different calcium-rich and silica-rich industrial residues. Larnite, wollastonite and calcium silicate chloride were successfully synthesised with moderate heat treatments below
Esquivias Fedriani, Luis María +4 more
core +1 more source
Development and Validation of a Next‐Generation Mechanistic Model of the Electric Arc Furnace
steel research international, EarlyView.This study presents a next‐generation mechanistic model of the electric arc furnace (EAF). It describes equations for all crucial processes appearing during the steel‐recycling process in an EAF, i.e., thermal, mass, and chemical. The model was parameterized and validated using industrial EAF data.
Vito Logar, Igor Škrjanc
wiley +1 more source
Behaviour of ground cupola furnace slag blended concrete at elevated temperature [PDF]
, 2020 Fires adversely affect the performance of concrete when expose to extreme temperatures. However, it is important to study the effects of elevated temperature on the concrete properties.
ALABI, Adeyemi Stephen, MAHACHI, Jeffrey
core
Pirometalurška obdelava katalizatorja z vsebnostjo srebra [PDF]
, 2018 The following article describes the thermal process for the recovery of used silver from Ag catalysts using an 80-kVA plasma reactor, along with an appropriate flux and reducing agent.
Kurilla, Peter +3 more
core +1 more source
steel research international, EarlyView.The experiments and simulations demonstrate that, in general, alternative carbon sources can decrease fossil CO2 without adversely impacting EAF process and product. High plastics and tires ratios cause unsafe conditions and poor slag foaming. Hydrogen in EAF burners decreases CO2 but increases water vapor, which can raise the hydrogen content in ...
Ismael Matino +7 more
wiley +1 more source
Seismic performance of coal ash slag concrete beam-column joints [PDF]
Journal of Hebei University of Science and TechnologyTo investigate the high-value and high-dose utilization of solid waste gasification ash in concrete components, low-cycle reciprocating loading tests were performed on joints within one ordinary concrete and three gasified ash concrete beam-column joints.
Jiaqi WEI +8 more
doaj +1 more source
The complex binder based on Portland cement andash-and-slag wastes from thermal power stations [PDF]
, 2019 Increase in the balance of boiler and furnace fuel of the energy sector of the Republic of Belarus the proportion of own energy resources (milling peat and wood chips) places priority on resolving the issues of utilization of ash-and-slag wastes and ...
Vysotskaya, Maryia
core
steel research international, EarlyView.Hydrochar‐mill‐scale briquettes with varying C/O molar ratios (0.07–0.90) have been tested at 1650 °C to evaluate their slag foaming performance for electric arc furnace application. All seven briquette recipes developed succeed in promoting slag foaming.
Yu‐Chiao Lu +3 more
wiley +1 more source
Development of methods for preparing fly ash for separation by activation [PDF]
, 2018 Purpose. Isolation of the aluminosilicate fraction from fly ash, study of physical and mechanical properties of binders obtained from TPP wastes. Methods.
Netyaga, O.B. +8 more
core
Structural Concrete, EarlyView.Abstract Steam curing is commonly used to manufacture precast culverts to accelerate early strength development. This study investigates the effect of supplementary cementitious materials (SCMs) on the permeability properties of steam‐cured precast concrete culverts.
Saugat Humagain +3 more
wiley +1 more source