Results 241 to 250 of about 542,284 (282)
Development and Clinical Feasibility of a Computer-Assisted Shape Design and Bending System for Spinal Fixation Rods. [PDF]
Med Sci MonitLi X +6 more
europepmc +1 more source
Gear Classification in Skating Cross-Country Skiing Using Inertial Sensors and Deep Learning. [PDF]
Sensors (Basel)Pousibet-Garrido A +8 more
europepmc +1 more source
Probabilistic Analysis of MEMS Asymmetric Gear Tooth
Design Engineering and Computers and Information in Engineering, Parts A and B, 2006 Asymmetric gear teeth are used to improve the performance of gears by increasing the load capacity or by reducing vibrations. Recently these types of gears have found application in MEMS devices where the use of gears is on the rise. In this research a probabilistic computer program, in conjunction with a commercially available finite element program ...
KARPAT, FATİH +2 more
openaire +4 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Effect of Compound Asymmetric Gearing on Dynamics of Gear Transmission
SAE Technical Paper Series, 2023<div class="section abstract"><div class="htmlview paragraph">The fast-growing automotive industry and rapid development of new E-drive technology nowadays brings about higher gear design requirements. E-motor applications challenge gear performance due to their higher load and speed levels compared to traditional internal combustion ...
Ned Wright +6 more
openaire +1 more source
Direct Gear Design for Asymmetric Tooth Gears
Mechanisms and Machine Science, 2016exaly +2 more sources
On the Behaviour of Asymmetric Cylindrical Gears in Gear Transmissions
2012Asymmetric gears have been proposed more than twenty years ago as the ultimate solution to increase the load capacity of gear drives while reducing their weight and dimensions. However, there are apparently contradictive statements in the literature regarding whether the higher pressure angle should be applied to the driving or coast side of the gear ...
Alfonso Fuentes +3 more
openaire +1 more source
Research on Asymmetric Gear Stiffness
SAE Technical Paper Series<div class="section abstract"> <div class="htmlview paragraph">To meet the need for optimizing the dynamic performance of asymmetric gear transmissions operating under high-speed and heavy-load conditions, this study presents a refined stiffness modeling approach.
Zeyi Zhao +5 more
openaire +1 more source
Direct Gear Design for Asymmetric Tooth Gears
2015In many gear drives, the tooth load on one flank is significantly higher and is applied for longer periods of time than for the opposite one. An asymmetric tooth shape reflects this functional difference. Design intent of asymmetric gear teeth is to improve performance of the primary drive profiles at the expense of the performance off the opposite ...
openaire +1 more source
“Asymmetric gear wheel: thermographic analysis”
2004We have studied an experimental system designed to measure the state of stress existing inside asymmetric gear wheels under load. Such experimental system consists of a test bench which constrains the two asymmetric gear wheels at the operating centre distance; a load is applied in order to simulate the cosntraint during operation.
GRASSO, Giovanni +3 more
openaire +4 more sources
Asymmetric Gear Noise Sidebands and Application to Planetary Gear Noise Reduction
SAE Technical Paper Series, 2005<div class="htmlview paragraph">Asymmetric sidebands of gear noise are frequently observed with a planetary gear set, and are different from typical sidebands that are symmetrical around the gear mesh order (or mesh frequency). The asymmetric sidebands are found to be caused by phase differences between the different mesh points.
Scott Yu, Stephen Kaatz
openaire +1 more source