Results 1 to 10 of about 1,139,985 (300)

Voltage regulation and power-saving method of asynchronous motor based on fuzzy control theory

open access: yesOpen Physics, 2022
The load rate of asynchronous motors is low, the operation efficiency is low, and the waste of electric energy is very serious. Therefore, a voltage regulation and electricity saving method for asynchronous motors based on fuzzy control theory is ...
Guo Chunjing
doaj   +2 more sources

Optimization and Experimental Validation of Amorphous Alloy High-Speed Asynchronous Motor for Simultaneous Reduction on Core and Copper Losses

open access: yesIEEE Access, 2023
Amorphous alloy has been proposed to replace silicon steel as the stator core material of high-speed asynchronous motors so as to reduce their core losses. However, it is found that this is at the expense of increasing the copper loss.
Jiahao Zhang   +6 more
doaj   +3 more sources

Equivalent Inertia Estimation of Asynchronous Motor and Its Effect on Power System Frequency Response

open access: yesEnergies, 2022
With the increase in renewable energy penetration, the traditional synchronous generator is gradually replaced, resulting in the decrease in system inertia level and the weakening of frequency modulation capability.
Xingyong Zhao, Penghui Qin, Zhen Tang
doaj   +3 more sources

Computational methods for studying the thermal state of frequency-controlled asynchronous traction motors [PDF]

open access: yesE3S Web of Conferences, 2023
The article discusses methods for calculating the thermal state of a frequency-controlled asynchronous traction motor, and provides calculations of the thermal state of an asynchronous motor powered by a semiconductor frequency converter with an ...
Iksar Elena   +4 more
doaj   +1 more source

Frequency support capacity of asynchronous motor and its equivalent inertia evaluation

open access: yes电力工程技术, 2022
The new power system is gradually evolving into a low inertia power system with high penetration of DC and new energy, and the inertia of the load side is gradually increasing.
ZHOU Tao   +4 more
doaj   +1 more source

Investigation of energy parameters of a compensated asynchronous motor in the mode of repeated short-term starts

open access: yesMachinery & Energetics, 2022
The study is devoted to energy efficiency management of induction motors with a short-circuited rotor of low and medium power and is a continuation of the development of the theory of compensated asynchronous motors.
V. Kaplun, R. Chuenko, S. Makarevych
doaj   +1 more source

Accounting for the effects of saturation of magnetic circuits for the mechanical characteristics of asynchronous traction engines

open access: yesTrudy Odesskogo Politehničeskogo Universiteta, 2014
The tangential and radial dynamic inductances on properties of asynchronous traction motors are investigated. Possibility of using the method of dynamic inductances at construction of mathematical model of asynchronous traction motor is shown.
Д.О. Кулагін
doaj   +5 more sources

Modeling of thermal process in the energy system “Electrical network - asynchronous motor” [PDF]

open access: yesE3S Web of Conferences, 2021
The paper discusses the influence of low-quality electricity on the temperature modes of operation of an asynchronous motor. In the course of experimental and analytical studies, the heat transfer coefficients and heat capacity of a particular ...
Kuznetsov Vitaliy   +5 more
doaj   +1 more source

NDIRECT MEASUREMENT OF THE ROTOR SPEED OF AN ASYNCHRONOUS MOTOR

open access: yesИзмерение, мониторинг, управление, контроль, 2022
Background. The object of research is electric drives based on an asynchronous motor. The subject of the study is the indirect measurement of the rotational speed of an asynchronous motor in such electric drives.
A.D. Semenov   +4 more
doaj   +1 more source

Development of an optimal control system with pulse control in the rotor circuit for cargo movement mechanisms [PDF]

open access: yesE3S Web of Conferences, 2021
The paper analyzes the methods of starting an asynchronous motor with a phase rotor. The control system used on the object under consideration, the mechanism of cargo movement, is obsolete.
Sinyukov Alexey   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy