Results 151 to 160 of about 5,276,046 (373)

Tribology of ZrC Coatings and Spherical Tips Acquired with Extraordinarily Stiff, Metal Atomic Force Microscopy Probes

open access: yesAdvanced Engineering Materials, EarlyView.
In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk   +4 more
wiley   +1 more source

Structural Analysis in Shoufengsi Area of Tananao Complex, Eastern Taiwan

open access: yesTerrestrial, Atmospheric and Oceanic Sciences, 2015
The subduction and collision boundaries of the Eurasia and Philippine Sea Plates in the Taiwan mountain belt expose a NE-trending coherent crustal section in the Tananao Complex.
Gong-Ruei Ho and Wei Lo
doaj   +1 more source

Atmospheric environment for space shuttle (STS-29) launch [PDF]

open access: yes
This report presents a summary of selected atmospheric conditions observed near Space Shuttle STS-29 launch time on March 13, 1989, at Kennedy Space Center, Florida.
Batts, G. W., Jasper, G. L.
core   +1 more source

Influence of a Standard Heat Treatment on the Microstructure and Properties of Inconel X‐750 Produced by Laser Powder Bed Fusion

open access: yesAdvanced Engineering Materials, EarlyView.
Ni‐base superalloys produced using additive manufacturing (AM) have a different response to heat treatments when compared to their conventional counterparts. Due to such unpredictability, various alloys with industrial interest are currently overlooked in most prior AM research.
Guilherme Maziero Volpato   +6 more
wiley   +1 more source

First‐Principles Modeling of Solid Solution Softening and Hardening Effects in Al–Mg–Zr–Si Aluminum Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
The role of various alloying elements in face‐centered cubic aluminum on the barrier of a Shockley partial dislocation during its motion is presented. The study aims to understand how alloying atoms such as Mg, Si, and Zr affect the energy landscape for dislocation motion, thus influencing the solid solution hardening and softening in aluminum, which ...
Inna Plyushchay   +3 more
wiley   +1 more source

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

Vacuum‐Formed Composites Based on a Polyolefin and a High Content of Biomass‐Waste Fillers

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown here that by the use of a very ductile polymer matrix, it is possible to vacuum‐form products that contain up to 25% of hard biofillers with still ductile properties. The results are promising and opens up for the use of engineered biocomposites derived from industrial side‐stream biofillers in vacuum‐formed products. A strategy to increase
Susanna K. Källbom   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy